Popular questions

Question
Crank but no start and there is no fuel pressure.
Hi there. Check the fuel pressure regulator on the fuel rail. The regulator will adjust the fuel flow and adjust the pressure. If the regulator is working, then there may be a restriction in the fuel line. Remove the fuel...
Question
P2006 Code (Replace Intake Manifold Runner Actuator)
This will not blow your motor up - it will degrade engine performance however, as you have already noted. The specific code suggests this valve is stuck shut. It may be possible to test this "off the vehicle", but remember...
Question
I'm hearing a clicking noise while the car idles in Drive, as the engine idles high.
You may be hearing a solenoid for the vapor purge control system. This would be normal if it is a ticking noise that sounds like a clock ticking only when you give it a little gas and goes away when...
Question
My abs motor relay is missing. Would that prevent my car from starting
If you are sure it is the ABS relay missing, then that will not prevent your car from starting. That circuit is unique only to the brake system. If the engine does not crank over fast when starting, you...
Question
2005 mini cooper s is parked and wont go into reverse gear. All of the other gears work except reverse.
Hello, thank you for writing in. The transmission may be having one of several issues. The shifter can become unaligned and need to be adjusted or replaced. The gearbox can also become damaged and misaligned, which also warrants them to...
Question
2008 Ford Mustang GT Stalls after warm up as if it ran out of gas and won't restart until engine is cooled
The issue is the fuel pump relay on your fuel system. The fuel pump relay is getting hot and shutting off the fuel pump. Then when you shut off the engine and key to the ignition switch, the fuel pump...
Question
Would a clogged catalytic converter burn a hole in the manifold
Hi and thanks for contacting YourMechanic. The hole in the manifold is a sign of something coming out of the engine, either a piston or a valve. If the manifold is the intake manifold, then there could be a burned...
Question
Misfire in Cylinder 3
Engine misfires can be caused by many different problems and are generally caused by either a spark or fuel issue or in some cases, a combination of both. Spark related problems generally will result from things like ignition coils, crankshaft...
Question
Loud jet engine noise when accelerating and when turning on AC
A few different things can cause this fault. Though 50,000 miles seems a bit early for most of them, the usual causes for the loud noise include: a failed idler, a faulty belt tensioner, an air leak, an exhaust leak,...
Question
only passenger side plug is carbon build up driver side is clean change plug doing same thing
Hello, thank you for writing in. The most common cause of carbon build up on the spark plugs is unburned fuel, also known as "running rich". Despite the assumption that the injectors are to blame, it usually has more to...
Question
My 2012 chrsyler 200 red security indicator light came on car won't start what does that mean?!!
This is a common problem in many of the Chrysler model cars. I would suggest taking it to the dealer to have the security system reset. The fact that this happened when turning on the defrost suggests a potential short...
Question
For some reason one of my headlights looks dirtier than the other. I've tried just about everything to get it to look new again an
Hi there. Over time, many different items can cause headlights to fade. In most cases, it's a caused by debris that naturally builds up on the lens that causes it to become cloudy. In other cases, the inner seal that...
Question
How do you replace the belt tensioner assembly on a nissan versa 2009 1.8 L. hatchback.
Hi there. Replacing the drive belt tensioner assembly on your Nissan Versa can be a tricky task without the right tools. You can request a price estimate to have one of our mobile mechanics come to your location and complete...
Question
Random no-start. Turning key and no response, I turn the key back off and turn it again and the car starts
Hey there. This is a sign of a faulty or failing ignition switch. When this begins to fail, this is usually a sign of the contacts inside the switch wearing out. When you put your key in the ignition and...
Question
Car won't start even though starter and battery tested good
Hi there. This sounds like an electrical issue your truck is experiencing. A bad connection will cause a surge of power just like the one you have. If your electrical system has a bad ground it will cause this sudden...
Question
Dead animal inside vents of vehicle.
I have seen a family of mice make a home inside the heater blower case. You may need to have the entire heater blower case removed, thoroughly cleaned out, and sanitized. This may be the only way to remove most...
Question
Dead battery from loose bolt connected to battery terminal
Yes, a loose-fitting or corroded battery cable to battery post connection can certainly lead to a dead battery. Corrosion builds up between the battery post and cable, creating electrical resistance. This becomes harder and harder for the alternator to charge...
Question
Car giving Code U1000.
The code you are getting is a lack of communication from or to the body control module. The problem has been fixed by other owners by replacing the ignition switch on some vehicles and had to replace the body control...
Question
Low beams not working
If the headlamp connector is plugged into the new unit, everything should work as designed. Looking at the wiring diagram for your vehicle, I see that the right hand and left hand low beams use separate fuses, so a blown...
Question
Car shuts off at speeds over 60 mph
Hey there, thanks for writing in about your 2001 Oldsmobile Bravada. You are losing ignition spark or fuel pressure to the ignition. The vehicle and year is known to have failures in both systems and the only way to diagnose...
Question
How to install A/C blower? 2008 Mazda 5
Hello - the blower fan and motor are way up under the center portion of the dash, requiring the removal of most of the dash. I would highly recommend a blower motor replacement by a mobile, professional mechanic, such as...
Question
Transmission slipping when going uphill
Hi there. Your hybrid has a continuously variable transmission (CVT), which uses internal pulleys and a steel belt. The transmission control module (TCM) controls the shift pulley ratio via solenoids, while receiving inputs from various sensors throughout the vehicle. If...
Question
Emergency brake locked up
This is a common problem for your vehicle. The emergency brakes in your vehicle are built into the rear calipers. Over time, corrosion will bind up the mechanism inside the caliper and will not allow the brake to release. The...
Question
Front Tires Wear on Inside Walls
If you are getting excessive inside wall tire wear you should have a mechanic like one from YourMechanic come to you and inspect the lower control arms for worn out lower ball joints or lower control arm inside bushings. Depending...
Question
Crankshaft sensor replacement - 2014 Toyota Avalon
Hi - the crank position sensor on the V6s is located at the "nose" (passenger side) of the engine, way down low. Rather restricted access. Will require safely raising and supporting the car, and access from underneath the engine. If...