Popular questions

Hello. When this code comes up it is because the computer is not detecting that the camshaft is moving as it should when the variable valve timing system is functioning. This can be caused by a number of things. It...

Hi there. This may be a sign of a faulty transmission control solenoid. Modern automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a transmission solenoid, which directs transmission...

I would recommend taking the battery out of your key fob to see if that makes a difference. It is possible that there could be a short within your key fob that is causing the locks to jump. This is...

Hi there - while the 2.8 may bolt up, and the (automatic) transmission is the same, the electronic control software is different. Swapping engine and transmission controllers from the 2.8l into your CTS MAY allow a relatively smooth swap, but...

Hello there. It is possible that the clicking is due to the brake job. A few different items can cause the clicking after a brake job. The two most common would be the backing plate rubbing on the the brake...

Hi there. A common problem that occurs after a head gasket is damaged is that valve guides or piston rings will also be damaged. Plus, if the engine was not fully removed and disassembled, it's likely that there is additional...

Hi Alex. Thanks for contacting us tonight. In most cases, a beeping noise after shutting the car off is caused by an alarm that has been triggered due to a system or accessory left on. I would check to make...

Among the remaining possibilities are defective motor mounts, struts, and engine operating condition (the engine needs to be looked at with a scope under load and a compression test might be helpful, too). If there is no problem with the...

Hello, thank you for writing in. The catalytic converter is there to remove certain emissions like CO and NOx before your exhaust is pumped into the environment. While this is the practical and "environmentally responsible" thing to do, your vehicle...

Hello. There is not enough information to definitively say what the issue is. Do the headlights not work when they are on normally, or on high beams? If this is the case, the issue is likely pertaining to the power...

Hi! "Unsafe to drive", are the words you may want to use when you bring it to the Acura dealer service department since it is still under the warranty. There have been some issues with the transmission on the Acura...

Hi there. Not sure what roads you can travel over 80mph but several things may cause this issue. One possibility is having broken or sagging transmission/engine mounts. Another possibility is a driveline vibration caused by worn CV joints and/or U-joints....

Hi there. Typically when your steering wheel feels stiff, it's an indication of two different possible issues. First, that you have a power steering fluid leak and the system is low on fluid or second, that there is an issue...

If your vehicle has the optional, factory installed towing package you will have the 160 amp alternator. If you never intend to tow anything the lower capacity alternator is fine and will fit. If you do not know whether your...

Look around the transmission and look to see where the shifter cable is attached. Feel the shifter cable and see if it is indeed damaged or broken. If the cable is broken, then it will need to be replaced. If...

The symptoms you described are textbook symptoms of a car in need of a valve adjustment. Most Japanese cars of this era used mechanical lifters, as opposed to hydraulic lifters found in many European cars. The upside of mechanical lifters...

For this, Silicone spray is one tool I personally like to use especially on rubber or silicone seals. The spray will leave a water-tight film on the electrical component and offers a moisture resistant coating. If you would like to...

Hi there. Check the suspension and shocks on the rear of the vehicle. If the suspension is loose or the shocks are worn, then the axle will move around or bounce and keep the tires from being in contact with...

Hello there. A few different items can cause the vehicle to have a high speed vibration. Most of the times these symptoms will start at 65mph or normal freeway speeds. The most common causes of this vibration includeL wheel(s) out...

The O2 sensor has many codes associated with the sensor itself. Some codes can indicate that your engine is running lean and alternatively some can mean that your engine is running too rich. The power steering and A/C have pressure...

Hi there - unfortunately, this is not a service YourMechanic offers at this time. This task is best handled by a collision repair estimator at a reputable paint and body shop. S/he is trained to evaluate visible and not-so-visible damage,...

This indicates the engine cooling system is low on coolant and will need to be topped off. The system should be inspected for leaks to ensure there are no other issues causing the engine coolant level to drop. Please note:...

It sounds like you may be having a fuel system issue. I would recommend having the fuel pressure tested by a qualified professional to determine the exact cause of this issue. Consider YourMechanic as this can be done at your...

The pcv valve may be stuck open or fell part inside causing excessive suction in the engine and high idles. Have the crankcase ventilation system checked for problems.

You may notice you may have less control in panic stopping or in wet or slick conditions. Your brakes should operate as if you were not equipped with ABS at all. After investigation of your complaint, there are a few...