Skip the auto shop - Our mechanics make house calls

Q: Windshield wipers don't work

asked by on

The windshield wipers don't work.

A: Hi there. If the wipers stopped working on ...

Hi there. If the wipers stopped working on all speeds then the wiper motor may have failed. I typically start with checking the voltage at the motor to see if it is present. If it is not then there may be a wiring issue. If there is voltage and if there is a signal from the wiper switch then the motor would need to be replaced.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: hesitation when accelerating and shaking when in idle

Hey there. A proper diagnosis at a repair shop is the only way to be certain. If the spark plugs have not been changed in 40,000 miles or more, the car would benefit from replacing them. But any number of...

Q: If the neutral safety switch goes out could the truck be started by arcing of the selonoid?

The neutral safety switch on the transmission or the ignition switch may be the cause of the no crank condition. There is a starter relay in a junction box under the left side of the dash. This relay will send...

Q: I think I got ripped off by my auto mechanic

From what you've described you may have blown the head gasket when you overheated the engine. The shop pressure tested and repaired the leaking hose but the engine may have already gotten damaged when it initially overheated. If you want...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...