Q: Will I have to take out the whole transmission or apart just to get to to that piece (transmission speed sensor

asked by on November 16, 2017

Transmission speed sensor do I have to take it out to get to that piece

My car has 13324 miles.
My car has an automatic transmission.

The output speed sensor is replaced from outside the transmission and is located on rear of transmission. No need to remove transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $65/hr

What others are asking

Car shaking and stalling

If your vehicle starts and then shuts off right away, the first thing I would check is to see if there is a Check Engine Light, and thus perhaps a trouble code that can guide us to the solution. Usually...

I have a Ford freestyle first it a has an helicopter noise wish i was made to understand its from the transmission if u put it on

Hi there. The wrench light typically indicates that maintenance or service is due on your Ford Freestyle. However, the "helicopter" sound does raise a few red flags, such as a damaged serpentine or fan belt, or possibly internal engine component...

Alarm kill Switch Cannot turn off

Most aftermarket alarm systems have some sort of control module that is tied into the ignition system to prevent the vehicle from starting. Depending on the brand and the installer, it could be under the dash somewhere or under the...

My car won't start 2001 Dodge Stratus

Hi there - your problem may be a weak fuel pump, and a bad starter solenoid (relay). The whine you now hear while the key is turned on is probably the fuel pump - a good sign. The fact that...

ABS light is on...1999 toyota camry

It sounds like you may have an issue with the ABS control module or the wheel sensors on your vehicle. The ABS control module controls the activation of the ABS system based upon inputs from the ABS wheel sensors. When...

Engine won't start.

You should get your 'no start' inspected by a qualified technician. The most common problem on this vehicle for a 'no start' is the fuel pump and filter. The fuel pressure will have to be checked by a certified qualified...

Clutch won't work and the clutch pedal has no pressure.

Hi there. Check the slave cylinder and see if its moving. There could be a leak on the slave cylinder causing the slave cylinder not to operate. Also, check the pin to the clutch pedal and make sure that it...

Key only spins in lock

It sounds like either your door lock cylinder or the linkage inside the door has come apart or failed. The linkages inside your door are connected by pieces of plastic essentially. It is possible that one of these connections has...

Windshield wipers only work on low

The wiper high setting is controlled through the wiper switch to "ask" the GEM module to turn on the wiper high relay. The most common problem is the wiper switch, but before the switch is condemned, it can be tested...

Related articles

Symptoms of a Bad or Failing Transmission Speed Sensor
Common signs include harsh or improper shifting, cruise control not working, and the Check Engine Light coming on.
Mercury Certified Pre-Owned (CPO) Car Program
Drivers Drivers who are shopping around for a used Mercury vehicle may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on to...
How to Replace a Transmission Speed Sensor
Transmission speed sensors accurately calculate a car's road speed. If this sensor is faulty, a Check Engine Light will indicate the driver.