Q: Sparks from battery after engine harness swap

asked by on August 15, 2017

Uppon swaping engine harness and attempting to connect battery again sparks came from cables touching the battery borh of them did it. Any advice ? Or tips on what to check ?

My car has 90000 miles.
My car has a manual transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I open and close the hood?
Being able to open the hood and then close it properly ensures that you’re able to keep tabs on the condition of vital things like engine oil level, brake fluid and the like. It’s simple to do, too. Just follow...
How to use old oil
It's hard to say. Oil is pretty mixable and it stays in the solution pretty well. Gasoline settles down but oil really doesn't. If he has gallons of that stuff, and if you've got lawn mowers, you can try and...
What signs do i look for to know if a car motor has a cracked block?
Some of the signs of a cracked engine block is oil and water being mixed. Any external leaks on the block can be coolant or oil. The problem with a cracked block is that you can have the same symptoms...
Car keeps stalling - 2001 Oldsmobile Alero
It looks as if you might have some sort of electrical gremlin inside your Oldsmobile Alero. I had a similar problem with my 2001, and we determined that it was a bad ignition relay (https://www.yourmechanic.com/article/how-to-replace-an-ignition-relay-by-timothy-charlet) that was shorting out the...
My oil pressure sending unit is faulty. What is the cost to replace it?
The cost of replacing your oil pressure sensor (https://www.yourmechanic.com/services/oil-pressure-sensor-replacement) will depend on what year and model your Ford is and sometimes the engine type as well. But you should know that oil pressure can be low even with plenty of...
The computer (ECM) says it's EGR flow and there is no other symptoms. What you think is the problem?
Either the EGR (Exhaust Gas Recirculation) valve is stuck in the open position or is closed and not opening. First try removing the EGR valve and cleaning it out. Then see if the engine light goes out after cleaning the...
can i use struts, axle, and sway bar from 2002 town and country and put it on a 2005 grand caravan
The front struts and sway bar on the two vehicles appear to have identical aftermarket part numbers. The axle from a 2004 Caravan appears to be a direct interchange for the 2002 Town and Country but the 2005 model year...
Rattling noise inside engine when AC/Heater/Air on
You may have a serpentine belt or tensioner issue and may need to have them replaced but first should have a mechanic like one from YourMechanic diagnose the problem to verify the noise.
I hear a clunk when putting my 2003 Honda Accord LX in reverse and drive
It sounds like your vehicle may be a bit low on transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or you may potentially have a bad transmission control solenoid. As you know, the transmission works on hydraulic pressure built up from the fluid inside and...

Related articles

A Buyer’s Guide to the 2011 Mitsubishi Endeavor
The The 2011 Mitsubishi Endeavor is a crossover SUV that manages to provide decent comfort, power and performance into a single package. This also marked the final year of production for the SUV, as it was phased out due to...
How to Build Weather Pack Connectors
Weather Weather pack connectors started off as a Delphi product and quickly became commonplace in the automotive world. Most wiring systems (https://www.yourmechanic.com/article/how-long-do-wiring-harnesses-last) use weather pack connectors in their assembly due to their benefits when compared to standard connectors. Weather pack...
B1992 OBD-II Trouble Code: Driver Side, Side mount Air Bag Circuit Short to Vbatt
B1992 trouble code means means that the voltage from the side mount air bag circuit is higher or lower than the parameters set by the manufacturer.