Q: serpentine belt change

The limp home mode helps protect your transmission if damage is detected. Limp home mode limits the transmission to only second gear, which keeps your vehicle safer, while also giving you enough power to get to a dealer. If you...

There can be a few reasons why your Dodge Magnum is experiencing intermittent starting problems. A faulty starter is a common component to fail, however a failing ignition switch or a failing starter relay can also be the culprit. To...

I would first check to see if your Check Engine Light is illuminated. If so, there are likely trouble codes that have been stored in your vehicle's PCM that may indicate what the problem is. In order to pull these...

Hello. This is something that is possible but it is not typically cost effective. The engine will fit in place but you will need to change over the transmission and all of the electrical and the computers. Once that is...

The lights that you have on and the vehicle going into fail safe mode is an indication you have a major system failure that will require computer to be tested for codes first. There are many possible codes it can...

Shaking or vibration (https://www.yourmechanic.com/services/engine-is-shaking-pulsating-or-vibrating-inspection) may be caused by many different things such as faulty spark plugs, poor fuel pressure or misfires. Other things such as a faulty idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) may cause the engine idle to drop below...

If you plugged in the actuator before installing it then you have ruined the new one and need to replace it then install it before you connect the electrical connector. The system will then relearn the positions.

Hi Barbara. There are several individual components that make up the charging system and can trigger a battery light to illuminate. Some of the most common parts that trigger a warning light, including the voltage regulator, one of the multiple...

If you are having problems with the idle air control valve you may have to replace it. If you just want to clean it you would need to have it removed or use an induction cleaner tool to pull cleaner...