Q: replacing leaking brake fluid reservoir

Hello, It looks like you are experiencing two different issues here with your Mazda 3. First, the shaky steering wheel at higher speeds is due to the the vehicle's tires being out of balance. Taking your Mazda to the nearest...

The VSS (vehicle speed sensor) buffer is located on the drivers side near the ECM. I have heard of instances where the connector between the VSS and the buffer has become disconnected. The wiring between the VSS and the buffer...

This may be related to a faulty starter solenoid. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. When this fails, it may cause a clicking sound and will not...

Hi there: Sometimes when a vehicle gets stuck in the mud, excessive mud will clog up sensors on the vehicle suspension or engine / transmission that will trigger the check engine light. However, it's also possible that the excessive wheel...

This may be a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...

Hello. Yes a bad starter could cause a car to need a jump start every few days. Additional power provided by an extra battery could be enough to get a weakening started going again. Your vehicle may have a battery...

Hello. It is possible that you have a bent valve but instead you may have a warped valve seat. Whether or not that is the case what is most likely causing the lack of compression in your engine is a...

The remove and replace labor time depends on the sub-model. The range is roughly 20 to 30 hours. As far as the parts cost, that depends on whether you want a brand new engine, a rebuilt engine, a used engine,...

The codes do not necessarily implicate the EGR system or the MAF sensor as a multitude of other faults are as likely. Basically, the codes suggest there is too little fuel, or too much air, in the cylinder charge (the...