Q: Replaced alternator and battery car still will not start it will crank

asked by on

My car turned off while driving wouldn't start. I replace alternator and battery and now it cranks but will not start
My car has an automatic transmission.

If the engine cranks at adequate RPM, be sure there is adequate fuel in the fuel tank and that the fuel is not old. Download any OBD-II trouble codes that have been stored and examine those codes for diagnostic clues. Check for adequate fuel pressure, injector operation, and a spark at the spark plugs. Basically, if the starter motor is turning the engine over rapidly, at sufficient RPM, but the engine does not catch and run, that means that there is an ignition, fuel, air induction, or mechanical fault in the engine that will have to be repaired. Check for vacuum leaks, an air induction fault like a stuck idle air control valve or, considering fuel, check for a failed temperature sensor that must be working properly to signal the PCM to enrich the mixture on cold start. Other possible no start faults are low compression, defective spark plugs, a defective coil(s), a failed crankshaft or camshaft position sensor, a failed throttle position sensor, and a broken timing belt. Regardless of the underlying cause, if you request a no start diagnostic the responding certified mechanic will get the problem diagnosed and repaired for you promptly. Please let us know if you have further concerns or questions as we are always here to help you.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Replaced alternator and battery car still will not start it will crank

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Cooling fan runs constantly

Hi There, It sounds like you may have a faulty coolant fan relay. The coolant fan relay helps to maintain the proper coolant temperature by turning on and off at specific temperature thresholds. When this relay is not working properly,...

Q: Car jerks at a steady speed.

This may be a sign of a dirty or failing mass air flow sensor. The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed with fuel prior to being injected...

Q: Steering rack and pinion play

The movement in the rack shaft is normal as far as I have seen in the video. With everything hooked up, use jack stands on both sides of the car to and support it below the lower control arms. Once...

Related articles

How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...