Q: Doors keep unlocking. Using both manual and auto-lock.

asked by on

Doors manually unlock within 20 seconds of locking them, using both manual and auto-locks.

I would have a technician inspect your electrical system. It sounds like you may have some electrical problems. There could be a shorted wire where the wires go into the doors or you may have a bad lock sensor on one of the locks.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Doors keep unlocking. Using both manual and auto-lock.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Q: No acceleration when I press the gas

If the engine just revs up after you put it into gear, I would suspect a transmission problem. But if you don't have any control over engine speed it's likely a linkage malfunction between the pedal and throttle body, or...

Q: Transmission lurches when car shifts from 1st to 2nd and 3rd gear

There are two possibilities. This could be caused by internal wear in the transmission. Fluid level and condition should be checked. If the fluid level is low or smells burnt it may be an indication of an overhaul needing to...

Q: Locking mechanisms malfunction - 2001 Mercedes Benz CL600

Hello. A few things I would look into are the battery and the central lock vacuum pump. A bad battery can cause all sorts of electrical malfunctions. If the battery checks out, I would then move on to making sure...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.