Q: Rear power window stuck

asked by on

The driver's side rear power window is stuck.

You could try to get it temporarily closed by holding the switch and gently banging the door panel near the middle of the door on both the inside and outside. If that doesn’t work try pulling up or pushing down on it, again while depressing the switch at the same time. Also try operating it from both its switch and the master switch. If none of these work, cover the window and contact a mechanic to inspect your window and come up with the appropriate repair.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!
  1. Home
  2. Questions
  3. Rear power window stuck

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Getting a "Drivetrain Malfunction" light on a 2011 535i. Had a sensor replaced for almost $400 and that didnt fix the issue. wha

Hello. The drive train malfunction light indicates the computer has detected an issue with the vehicle's drive train or transmission. This can be caused by many things, ranging from a bad sensor, to the need for a new transmission. As...

Q: Car won't start, fuel gauge and speedometer malfunctioning

Hello there, the first place I would look, with all of the symptoms you've described, is into the no start condition. The most likely cause of a no start would be a problem with the battery, starter, ignition switch, fuel...

Q: My car is Shaking prior to that my car said I needed 1 quart of oil

If your indicator just came on saying you needed a quart of oil, you probably haven't done any damage. Most cars can run for a long time while a quart low. But you don't want to ignore this, especially with...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.