Skip the auto shop - Our mechanics make house calls

Q: PCV Valve Location

asked by on

I know of the pcv valve on the oil funnel neck but a mechanic said there is a second one. I am just needing to know where it is.

My car has 147000 miles.
My car has an automatic transmission.

A: This engine has only one PCV valve and it i...

This engine has only one PCV valve and it is located in the oil fill tube. If you need help replacing PCV valve contact a mechanic like one from YourMechanic to perform any services you need.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Engine runs rough sometimes and then it cuts out.

Hi there. With the conditions that your vehicle is having is that the mass air flow sensor (MAF) is probably dirty and not functioning correctly. I recommend cleaning the mass air flow sensor with electrical cleaner and then putting it...

Q: truck is ticking.

Hello, thanks for writing in about your 2001 Grand Cherokee. It is possible that a cracked flywheel will make noise and also cause the crank position sensor to be given bad information. That may be the source of the Check...

Q: Ran great, died on highway, added 2 qrts, ran 5-6 miles died again

You need to check the PCV system and air filter to see if it is clogged. Remove the oil cap and start the motor after you fill the oil and see if you see smoke come out of the oil...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.