Q: Passing gear

asked by on December 28, 2017

Passing gear not kicking in
My car has an automatic transmission.

You should have the computer scanned and transmission linkage checked to see if the system has codes stored for transmission and shift linkage is not damaged and adjusted properly.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Temperature gauge on dashboard

If by replacing the "temperature valve" you are referring to the thermostat (which does in fact act as a valve in a way), then you might have an electrical issue. Assuming with the repairs you have done, that the cooling...

I just want to know if my car has a crankshaft position sensor - 2003 Nissan Xterra

Hi there - yes, your V6 Xterra has a crankshaft position sensor (CPS). It is located behind the driver-side cylinder head, on the top of the bellhousing (the aluminum casting that connects the engine and transmission). For assistance with replacing...

Rough idle, missing, almost dies when in gear, shaking violently when driving in low speeds

Hi, thanks for writing in. I'd be happy to provide my insight. I recommend you have the engine checked for vacuum leaks, or and check if carbon is clogging the EGR valve. If you still cannot find the reason the...

2004 Ford Ranger doesn't turn off when key is removed

The problem is likely a bad ignition switch. The ignition switch routes power to the entire vehicle including the accessories, computers, fuel and ignition system. Basically, the failed switch is allowing the vehicle to stay on. A professional, such as...

How do I tell what size lug nuts I need for my rims?

The lug nut bolt pattern on your vehicle is 4 x 114.3. In practical terms, that means that an imaginary circle drawn through the four "bolt holes" will have a diameter of 114.3 millimeters. Of course, a bolt pattern designated...

Water leaking into passenger's seat

It is very possible that your sunroof could be leaking water into your vehicle as this is a common problem. I would recommend having your rubber insulation and weather stripping checked to see where the leak is coming from. You...

My car want accelerate and my engine light is constantly blinking on and off

Hello. A misfire under load is typically caused by a problem in the secondary ignition system (i.e. plugs, wires, coil pack). This will also cause your Check Engine Light to flash. The powertrain control module (PCM) directly controls coil operation,...

My power steering pump pulley broke into pieces but pump spins freely, do I just need to replace the pulley?

Hi Bridgett. Thanks for contacting us today. When a pump spins freely as you've indicated, it's usually best to replace the pump, as it's possible that damage has been done to the pump when the pulley broke.

Lack of power 1991 Nissan 300ZX

Hello and thanks for writing in. There are a number of things that can cause the motor to over fuel or run rich. When this happens, it is usually related to things like faulty fuel injectors, a failing mass air...

Related articles

Symptoms of a Bad or Failing Neutral Safety Switch
Common signs of a faulty neutral safety switch include the engine not cranking in park or neutral, not cranking at all, or cranking in any gear.
Does An Automatic Transmission Have a Clutch?
Most of the time we think of a clutch in the context of a manual transmission. An automatic transmission does have...
How an Automatic Transmission Works
An An automatic transmission allows a vehicle engine to operate within a narrow speed range, just like a manual transmission does. As the engine achieves higher degrees of torque (torque is the rotational power of the engine), the gears in...