Q: Parasitic battery drain

Nissan just issued a recall NHTSA Campaign #15V573000 dated 9/17/2015 that the dealer will replace the two front coil springs. You should have or will receive the recall from Nissan. You should contact your dealer and schedule the repairs as...

The instrument panel brightness can be adjusted so that it is as bright or as dim as is comfortable for your eyes. It is very easy to adjust the brightness: 1. Turn the ignition to On. 2. Turn the parking...

The most common cause of this would be a clicking relay or something else that is loose. This is a more uncommon issue that will require diagnosis to confirm. A qualified technician, such as one from YourMechanic, will be able...

A faulted sensor like the steering angle sensor (https://www.yourmechanic.com/services/steering-angle-sensor-replacement) can cause these systems to malfunction. A steering angle reset is required with an alignment on these vehicles and involves a procedure that includes disconnecting the battery. If you'd like a...

Hi there, thanks for writing in. Sounds like this may be related to either transmission components failing, or potentially a fuel delivery problem which may also create the jerking feeling that you're describing. Does the car run fine when in...

Your battery and charging system will need to be tested to see if the alternator is charging correctly. The alternator is most likely the cause of your Charge Light and Battery Light (https://www.yourmechanic.com/services/battery-light-is-on-inspection) coming on. You should replace the alternator...

Sudden up and down fluctuations in the engine coolant temperature gauge signify a gauge, sensor, or wiring fault. To resolve that problem, the service to request is a temperature gauge diagnostic (https://www.yourmechanic.com/services/temperature-gauge-is-maxed-out-inspection). The radiator could be partly cold if the...

If the thermostat housing is leaking after you replaced the thermostat then you either did not seat the thermostat correctly or the housing is cracked. Remove the housing to check for cracks.

Yes, it is possible the loose shifter is a consequence of the ignition switch breaking as there is an interlock between the two. The recall relates to the ignition switch not retaining the key in the run position, thus potentially...