Q: P0016p0017p0301p0303 code show up on my GS 450h and even my Chinese shop doesn't want to fix it for two years now, something crank

Nissan just issued a recall NHTSA Campaign #15V573000 dated 9/17/2015 that the dealer will replace the two front coil springs. You should have or will receive the recall from Nissan. You should contact your dealer and schedule the repairs as...

Your car is equipped with an Illuminated Entry system that turns on the lights to provide better visibility when getting into the vehicle. Here’s how it works: When you use the remote to unlock the doors, the interior lights should...

The MyKeys can be cleared very easily by following these steps: 1. Press the Up/down buttons on the steering wheel until Settings is displayed, then press the OK button. 2. Press the Up/Down buttons until MyKey is displayed, then press...

Hi there. The sunroof module takes input from the sunroof switch and in turn, operates the sun roof motor. If the sunroof is not working, the problem is with one of these components, or there is a mechanical failure of...

Hello there, when the D light is blinking on the dashboard this means there is a transmission fault. Many different issues can cause this fault. The most common would be a low transmission fluid level (https://www.yourmechanic.com/services/transmission-fluid-service), a mechanical transmission fault,...

The problem is addressed in technical bulletin 06-07-30-023E (http://ww2.justanswer.com/uploads/heavychevy396/2009-12-20_153913_6-07-30-023B.pdf). The problem is a slipping second clutch inside the transmission and requires the clutch and steel clutch plates and seals to be replaced. This requires the transmission to be removed and...

Hi there. To pinpoint this issue I would definitely start by getting under the car to try and find the location of the noise. Most of the time this is caused by a failure in the air conditioning compressor (https://www.yourmechanic.com/services/ac-compressor-replacement)...

Hello. A no spark (https://www.yourmechanic.com/services/car-is-hard-to-start-inspection) condition can be caused by many things. If the aforementioned components have already been replaced I would move on to looking at the ignition module, and perhaps the wiring to a few specific components. The...

Hi there. Your truck is from the 1999 model year so it is fully OBD-II compliant. That means that the computer "runs" the show and the only way the car can be tuned is if the oxygen sensors are operating...