Skip the auto shop - Our mechanics make house calls

Q: Need location of verable timeing senaloide

asked by on

Need to replace the verable timing selanoid

My car has 122000 miles.
My car has an automatic transmission.

The variable valve timing solenoid is mounted in the front of valve cover near the front of each valve cover near timing chain location in front of the motor.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Can a camshaft position sensor fail due to low oil levels? 2005 Dodge Neon

Hello - it is possible but not likely for a camshaft position sensor to fail from a low oil level directly. If the oil level is very low, to the point where the engine overheats however, yes. Excessive heat can...

Q: Car won't drive and shakes when I put my feet in the gas pedal

What you are experiencing is referred to as a "loss of power". Among common possibilities for loss of power are throttle body faults (electronic throttle controls, mass airflow sensor, torn air intake hose), worn out spark plugs, faulty fuel pump...

Q: Cylinder misfires

Sometimes an ignition coil failure may be due to outlying causes like oil on plug wires or plugs with too large of a gap. If the coil has to work too hard to jump the gap, the spark plugs can...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.