Q: My suv radiator hose busted while i was driving and my car stoped accelerating now it won't startany advice?

The problem will need to be checked (https://www.yourmechanic.com/services/car-is-hard-to-start-inspection) to see if you are loosing ignition or fuel to your engine since the most common problems are the fuel pump, engine module and distributor going bad on these engines.

I am assuming you have an automatic transmission because you had it flushed. Hard to shift issues can be caused by a bad cable that goes from the shifter to the transmission shift lever, The cables will get dirty and...

You should start by having the starting and charging system thoroughly tested to ensure both systems (https://www.yourmechanic.com/article/alternator-or-car-battery-how-to-tell-which-part-is-the-problem) are working properly. It sounds like you have a large parasitic drain, which means something is drawing power from the battery when the...

The PCV system on this engine is incorporated into the air filter housing and has no serviceable parts. If there is excessive oil in the air filter housing then the entire housing would need to be replaced as an assembly....

Whenever your Check Engine Light is on and a code is set, the ECU resorts to base settings and mapping just to make sure the vehicle runs, but not necessarily the to help the car run well. In this case,...

Hello there, thanks for writing in about your 1993 Chrysler Lebaron. A few different faults can cause the power steering to stop working. If the power steering has completely failed, then the most likely causes would be the power steering...

Hi there, thanks for writing in about your 2000 Chrysler Cirrus. The buzz is most likely coming from the blend door actuator motor on the evaporator case under the dash. The actuator would need to be verified as to which...

Hello. This is a problem of which Ford is aware, and there are several Technical Service Bulletins from Ford for this issue (#15-0114 and #11-11-6 among them). Check with your Ford service center regarding this issue, and look to these...

Hello. A vehicle that stalls when put into gear can be caused by a few different things. A few common causes are engine performance or transmission issues. If the engine encounters performance issues such as fuel problems, or a fault...