Q: My car is very loud when accelerating and smokes when running, stops immediately when the car turns off.

In Hyundai vehicles you need to have a special scanner to reset the tire pressure monitor system when a sensor is replaced. The scan tool will wake up each sensor and record its serial number. After you have each tire...

Unfortunately, you will have to wait for the seal to arrive. Multiple companies will make a seal for your car, but that doesn't mean they are available in the small town you are in. I assume you have your car...

Hello. From what you describe it would appear that the vehicle is experiencing more than one issue. The first thing I would address is the alternator, as a faulty alternator can leave the vehicle stranded if the battery dies. I...

Your symptoms suggest that the starter solenoid contacts are burned enough to stick in the "Start" position (engaging the starter drive and motor), even when the ignition switch is not energizing the relay portion of the starter solenoid. The starter...

This may be a thermostat issue where the thermostat is not closing at the right temperatures resulting in the coolant running continuously throughout the motor which does not allow the engine to reach normal operating temperature. As you may know,...

I am working on this

Most of the time, the hard to start issue you're describing is caused either by the crankshaft position sensor or the electrical harness attached to this component. Since you've replaced most of the ignition system components, you might want to...

Hello. If the powertrain control module detects that there is an increase or decrease of the crankshaft revolutions per minute that is more than 2 percent, it will store the P0301 trouble code. A percentage increase or decrease in revolutions...

It could be that the battery in the key fob is weak. The key fob uses a watch battery and it lasts a long time, but won't go on forever. The batteries are usually standard items that you can buy...