Q: Just had car checked due to rear noise. Shop rear strut mount was going bad. 1200 dollars to repair. This because you have to take

Hi there. Sounds to me that your brake pads have worn past their limit causing the metal base to press against the brake rotor which is leading to metal on metal contact. A brake service is due for your car....

A technician with an advanced scan tool can verify the issue. The mirror system is complex and involves many modules. The Body Control Module is a possible cause, but it's doubtful; replacement requires reprogramming, which requires special equipment. I would...

Hi, check the rim and see if it is damaged at all. You may have hit the rim and the body of the car will be fine. The wheel however is misaligned, especially if the steering wheel is wobbling a...

Hi there. Thanks for writing in about the windshield wiper issue (https://www.yourmechanic.com/article/how-windshield-wipers-work) on your 2013 Chrysler 200. It's pretty rare that this happens with a newer vehicle like yours, but there are a few potential issues that might be causing...

Hi there. From the description you have provided, it would appear, you have covered the bases concerning your vehicle's inoperative blower motor. However, I am lead to believe the problem is still, no power supplied to the blower motor connector....

Hi there, thanks for writing in. Any number of things can cause an engine to stall. Assuming, the Check Engine Light is not coming on, leads me to believe the ECM (Engine Control Module)/computer is not recognizing the fault. The...

Hello, thank you for writing in. There is a chance that the misfiring is being caused by the coolant leak/overheating issue. The first thing you want to do is find the source of the coolant leak, and take corrective action....

Intermittent problems with no codes are the hardest to identify the cause. You may have a problem with the fuel pump intermittently sticking off or a relay that is not coming on intermittently in the (TIPM) Totally Integrated Power Module...

A no start condition after a battery replacement can be caused by the theft system or the computer or ignition module may have been damaged during the process of the battery going bad or jump starting. I recommend having the...