Q: It happened a few time and a message will come up saying shift to P I don't know what that means.

First to talk about air filters--K&N air filters are lubricated air filters. They have an element in them, but it's got oils in it. So, they do clean quite well and they flow a little bit better. If you have...

This vehicle may have a wire harness issue (https://www.yourmechanic.com/article/how-long-do-wiring-harnesses-last) of bad crimps on the connectors to the cluster, engine control module (ECM) (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-engine-control-module-ecm), and other areas that can cause these intermittent failures. The codes you are receiving are most likely...

It is highly unlikely that these two issues are related. The issue you are likely having is that the mode door actuator has failed. The mode door actuator controls the mode door which will move in different directions to block...

The throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement) (TPS) is most likely failing. Air leaks in the intake can also generate a high idle, but not usually this high. If you need to have this checked, have a local mechanic, like one from...

Many times when a vehicle has been involved in a flood, it is typically considered to be totaled. There are so many electrical systems in newer automobiles that it would be very tough to test everything for water damage. I...

Hi there: It's highly possible that the source of your front end noise is a faulty or worn out wheel bearing. In most cases when the wheel bearings wear out, the noises are caused by lack of lubrication or metal-to-metal...

Hi there: If the mechanic completed the O2 sensor replacement, reset the codes and the error code was triggered again, it is possible that the catalytic converter is damaged (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-catalytic-converter) and needs to be replaced. However, it's also very common...

Hello, As you may know, there are a number of things that can cause a misfire ranging from faulty ignition parts to changes in air/fuel mixture, fuel pressure, timing an the list goes on. If you do know you have...

The slip and vdc lights are related to the traction control system on your vehicle. The traction control system works in conjunction with the engine. When the wheels begin to slip, the traction control can temporarily disable the engine to...