Q: Is there a tracking device on it

Transmission issues will often give you small signs that a trip to the shop is needed. The warning signs can be subtle shifting problems like a slightly delayed or harsh shift, sometimes even a delay before the transmission goes into...

The most important thing when inserting a CD is to make sure that the CD is facing the correct way. Make sure that the top of the CD (the painted side) faces upwards, and then push the CD into the...

Seat belts aren’t all that complicated, but they must be used correctly in order for them to do their job. They’re more important than air bags, and are actually the only “lifesaving” features on your car. Using them incorrectly can...

The first thing to check is the computer for any codes. If you are getting misfire codes like P030x (https://www.yourmechanic.com/article/p0300-obd-ii-trouble-code-random-multiple-cylinder-misfire-detected-by-jamahl-walker), then you have a cylinder that is misfiring. The "x" is the cylinder that is misfiring. Also look for a...

Noises such as this require some creativity to locate. The first challenge is recreating the noise. It is good that you are paying attention to the conditions it occurs and does not occur during. These kinds of details can help...

Hi there. Assuming, the engine is not turning over. The grinding noise you hear may be the starter drive gear failing (https://www.yourmechanic.com/services/starter-replacement). The oil light (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-the-oil-light-on) popped up on the dash with the engine not running would be considered normal....

A faulty crankshaft position sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) could cause hard starting but to determine if the sensor itself is faulty it has to actually be tested. Often, there will be a Diagnostic Trouble Code (DTC), that is generated by the car's...

Hi there - the first task is to have the transmission fluid level (https://www.yourmechanic.com/article/does-an-automatic-transmission-have-a-clutch) checked. This will require technical assistance and a lift, since there is no dipstick on this model, and the fluid level "port" is underneath. Correct fluid...

With the information you have given it would not be able to be determined if you would have any further problems after replacing the computer. Since the vehicle is over 16 years old and has over 220k miles there is...