Q: Is my car worth fixing

Hey there, thanks for writing in about your 1998 Altima. You may have a crankshaft (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) or camshaft sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) causing the no start. You can scan the computer and watch the data to see if one or both of...

In today's vehicles, the majority of cars are able to go between 5,000-6,000 miles between oil changes depending on the health of the car's engine and assuming you are using a quality oil. For some, this is a matter of...

Hi and thank you for contacting YourMechanic. Most likely what has happened is that when you were compressing the caliper to install the new brake pads, you compressed the caliper too fast and blew out the inner seal(s) in your...

Hi there: Anytime a check engine light is illuminated it's because a sensor has detected a mechanical or electrical fault that impacts the vehicle's performance. If the mechanic you go to hasn't completed a check engine light inspection; which means...

You may have a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. Since...

If the pulley moves back and forth, this would suggest that it is loose. Depending on which pulley it is, this may cause the belt to squeak if it moves back and forth due to the amount of force being...

Unless there is a maintenance specification in the Factory Service Manual for your specific vehicle, it is not "required" to change the power steering fluid. However, it is wise to change the fluid (https://www.yourmechanic.com/article/how-often-does-my-car-need-a-power-steering-fluid-service) at a reasonable interval because power...

Hi there. Check the suspension and the shock absorber and look for anything broken, leaking, or damaged. Replace the shock absorber is there is any dents or it is leaking oil out of it. A loose suspension component or a...

This could be a result of the brake caliper sticking. A few different things can make the brakes stick or lock up. The master cylinder may be causing this if it has not been properly bled. If you loosen the...