Q: I took a engine out of a tahoe 1995 Ls and i got a vorteck engine can i put every thing on the tahoe engine

The interior alarm can sound in a variety of ways to alert you when something is not correct. If the alarm sounds a single time, and has a flashing yellow key indicator, then the battery in the electronic key is...

There can be a variety of reasons as to why your Mazda Millenia will crank but not start. We can eliminate the starter and battery as a concern, since we know from the description that it cranks, therefore I would...

Hello. In newer vehicles with electronic fuel injection and ignition systems, engine knocking (https://www.yourmechanic.com/article/what-does-it-mean-when-an-engine-knocks) due to bad fuel or spark is extremely rare. In most cases, if the knocking sound is consistent and increases in speed as the RPM increases,...

Hello. Either the two big terminals are touching each other on the starter solenoid or the starter solenoid is shorted internally. You should check to make sure the two large terminals are not touching. If you would like to have...

Hello. The pressure switch (or "sensor") (https://www.yourmechanic.com/services/power-steering-pressure-switch-replacement) on your vehicle supplies a signal to the engine computer to increase engine idle speed as the power steering line pressure increases. If the switch were bad, what you would notice is the...

Hello - for a "no spark condition (https://www.yourmechanic.com/question/no-spark-at-spark-plugs)", I would check for problem codes first, whether the Check Engine Light is on or not. Any saved codes, whether transient, or permanent, could be very helpful with this diagnosis. I would...

Hi there. From the description you have provided, the alternator may not be keeping up with additional load of the air conditioning system. This could be the result of, a loose/worn drive belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement) or a faulty voltage regulator which...

Hi there. I watched the video and was unable to determine for sure what is causing this noise. However, it resembles a damaged tie rod or wheel bearing. It is true that if the component wears out too much, it...

The camshaft position sensor will make the engine run but poorly. Check the crankshaft position sensor to see if its damaged or unplugged. A damaged crankshaft position sensor will cause a no spark condition. If you need further assistance with...