Q: I have a g35 manual that rattles out of gear but run smooth when clutch is pushed in

Each front seat has a head restraint to help protect the driver and the front seat passenger in the event of an accident. When you get in the vehicle, you should adjust your head restraint so that the top of...

Hello. The rotors on most cars have a minimum thickness that they can be before they should be replaced. The minimum thickness is stamped into the rotor. The rotor can then be resurfaced until it gets too thin and should...

All modern cars are equipped with an Evaporative Emission Control (EVAP) system. The EVAP system prevents fuel vapors from the fuel tank from escaping into the atmosphere. The EVAP system collects and temporarily stores the fuel vapors in the charcoal...

The water pump on this engine is turned by the timing belt for the engine. Anytime you need to replace the water pump (https://www.yourmechanic.com/services/water-pump-replacement) you should also replace the timing belt. (https://www.yourmechanic.com/services/timing-belt-replacement)

Hi there. Wheel location is determined by imagining you are sitting in the driver seat. Your, and most vehicles today, have 2 axles in the front; certain vehicle still have a solid rear axle housing, but retain 2 individual axles...

Hello, What you are describing sounds like you may have a faulty traction control module or possibly faulty wheel speed sensors. The traction control system monitors the steering stability of the vehicle and engages when loss of traction has been...

Hi - I suspect your rough idling (https://www.yourmechanic.com/question/what-is-causing-really-rough-idle-by-devon) is an air leak (loose hose or crack in the air intake), or dirty idle air control valve. A leaking exhaust gas recirculation (EGR) valve would also cause rough idling. I recommend...

This suggests your power steering pump may be failing or you have a leak elsewhere in one of the power steering lines. The [power steering]((https://www.yourmechanic.com/services/power-steering-fluid-is-leaking-inspection) system operates on very high pressurized hydraulic pressure (in some cases as much as 300...

If the noise goes away when you let go of the accelerator, it's probably an engine or exhaust system related noise, and you are just simply hearing it through the vents. To have a noise such as this pinpointed, the...