Q: https://goo.gl/images/CcmhQf What the plug called by the oil dip stick

Hello, since you tried jumping the vehicle with the same result, there are two possibilities. The most likely is that the starter motor has failed. The second is something keeping the engine from turning. To get a complete diagnosis of...

The problem is most likely a breakage in the transmission's internal output or input clutch. Another possibility is that a shaft broke when you started to move or the differential final drive gear broke. Before the transmission is taken out...

Hey there. I would recommend taking the vehicle to a local dealer to have the vehicle checked for recalls and also technical bulletins for this engine. There are cylinder head replacement and timing chain replacement recalls (https://www.yourmechanic.com/article/what-to-do-if-your-car-is-recalled-by-jason-unrau) that may pertain...

Hi there - it's possible that your problem source is the torque converter lockup clutch (https://www.yourmechanic.com/question/car-hesitates-and-then-jerks-to-go-into-first-gear-by-brenda) NOT releasing as the truck slows down. This would lug the engine as though it's in top gear until vibration, or an engine stop/start...

Power Mazda Suzuki Address: 3248 Market St Ne Salem, OR 97301-1815 Scott Esty Suzuki Address: 2910 Se Main St - Portland Portland, OR 97214

There are literally hundreds, if not thousands, of possible causes for the check engine light to come on (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection). The only real way to know what has caused the light to come on is to pull the diagnostic trouble codes...

Hi there. To be honest, this would require you to replace not only fabricate new motor mount brackets, but completely swap out engine, transmission, drive shaft components. The V-12 is a much longer block so everything behind it would also...

The camshaft position sensor on this vehicle is attached to the timing chain cover. Note that replacement will require a PCM re-learn procedure in order for the engine to work properly. These sensors MUST be directly tested (or observed via...

Hi Garrett. Thanks for contacting us today. The Vehicle Stability Assist light shouldn't impact the vehicle's ability to accelerate unless a limp mode has been triggered and activated due to a malfunction of the system. This might be the source...