Skip the auto shop - Our mechanics make house calls

Q: How to change the lifters

asked by on

Can you tell me how to change he lifters please

My car has 115000 miles.
My car has an automatic transmission.

A: In order to replace the valve lifters, remo...

In order to replace the valve lifters, removal of the valve covers and rocker arm assemblies is required. The job can be a little extensive and many of the fasteners removed cannot be reused or they may cause damage to the engine. I wouldn't advise on going at this repair alone if you are not experienced since the job can be a bit more involved. Have an expert diagnose any issues and perform the repair for you if you need some assistance.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: .can the clutch on a.c. compressor freeze up taking out serpentine belt, and a.c. compressor be ok

As you may know the AC Clutch is the pulley that spins with the Belt. There are two ports on the rear of the Compressor. One is a Suction Port and the other is the Discharge Port. The Suction port...

Q: Put a water pump and timing belt on it and alternator it crunk up for 20 seconds and cut off now it wont start but does tirn over

Assuming the vehicle was running before the timing belt was replaced, I have to ask, are you sure you lined up the timing marks correctly? This would be the first thing I would check myself if I were working on...

Q: Having problems accelerating at high speeds causing jerking feeling...this happens when slightly pushing gas pedal

This problem of a slight jerk feel is what is known as a lean tip in surge. The cause can be an indication that the engine is running lean and may be caused by dirty injectors, throttle body, air filter,...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
How to Renew Your Car Registration in Oklahoma(DELETED)
Having your car registered with the Oklahoma Tax Commission is an important part of driving legally in this state. You will need to do this within 30 days of moving to Oklahoma...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...