Q: How do I use SelectShift?

asked by on December 11, 2015

How do I use SelectShift?

Your truck is equipped with an automatic transmission that comes with SelectShift. SelectShift allows you to manually change the gears of the transmission even though the car is automatic. To use SelectShift.

  1. Move the gearshift from drive to manual.

  2. Press the + button to shift up a gear.

  3. Press the – button to shift down a gear.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

can you replace the 700r4 with the turbo 400?

The turbo 400 was used on a lot of trucks with the 5.7 engine and should be bolted up if it came out of an engine with a 5.7 or 5.0 engine. As far as the drive shaft and length...

How do I permanently disable the rear view monitor system?

Your car’s rear view monitor system is designed to provide you with greater safety in situations where you need to see behind the car when backing up. However, it can be disabled both temporarily and permanently (it can be enabled...

How do I use the power outlets?

You’ll find three 12-volt power outlets in your car. These are designed to be used with portable electronic devices (charging your cell phone, for instance). They are NOT compatible with cigarette lighters. Using them is simple. Here’s what you need...

Car is overheating, usually when it's hot and the engine idles.

You most likely have a transmission cooler that is leaking into the coolant inside the radiator. The transmission cooler is built inside the side tank of the radiator, and if it blew out, then you will have transmission fluid getting...

When rev engine, short lag and slows to idle

You did not mention the engine you have in your truck, but I would suspect the engine turbo vane control is sticking when you rev the engine and will cause the engine to stay revved until the vanes go back...

Diesel trucks idles fine but after driving doesnt idle

You will need to have the charging system and batteries tested to see if you have a defective battery or the charging system is not recharging them. Since you say you jump started engine tells me the batteries were dead...

2011 Ford Fusion won't shift gears.

The first thing to check would be the transmission fluid level. If the fluid level is low from a leak, this may cause the transmission to slip and when revved to higher rpm it may jerk when the line pressure...

How do I turn off the flash lamps?

Flash lamps are a locking and unlocking feature. When you lock or unlock your vehicle with the remote keyless entry (RKE) transmitter, your turn signals flash on and off. This acts as visual confirmation, and can also help you see...

Car bucks, jerks, and idles rough - 1991 Ford Mustang

Hey there. This may be a sign of a failing idle air control valve. The idle air control valve is located on or near your intake manifold and monitors the air intake as it is mixed with fuel prior to...

Related articles

A Buyer’s Guide to the 2012 Audi A5
For For drivers who want a comfortable ride, expert handling and luxurious amenities, the 2012 Audi A5 will certainly fit the bill. Designed for performance and to deliver a gorgeous look, this model offers an array of options and features...
A Buyer’s Guide to the 2012 Audi A3 TDI
Consumers Consumers steered clear of hatchbacks for a while but Audi has brought a stylish, functional, high-end option into the arena and buyers have responded. The A3 TDI offers all the versatility and performance you expect from Audi in a...
How a Hydraulic Clutch System Works
If your car transmission has a hydraulic clutch, chances are you’re wondering exactly how it works within your shifting system. Most clutches, especially...