Q: How do I choose a radio band?

There are a few components that could cause this abnormal shake such as the motor mounts, belt pulleys and spark plugs. The most common cause of the shake being from faulty motor mounts. I suggest having a trained mechanic, such...

After doing some research, the only thing I found that has only two wires to a connector in the back of your motor is the evaporative control valve. The CHT is in the front of the motor and this engine...

There are many reasons as to why the car may no start, some of which may be related to various sensors. The most efficient way to approach something like this is often times to have the car's computer scanned (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection)...

Diagnostic trouble code P2004 (https://www.yourmechanic.com/article/p2004-obd-ii-trouble-code-intake-manifold-runner-control-stuck-open-bank-1-by-jamahl-walker) signifies a problem with a segment of the engine's air intake and control system, technically known as the intake manifold runner control (IMRC). In practical terms, the code means that the engine is not getting...

Hello. If your fuel was recently contaminated with water then that is likely the reason behind the cylinder 2 misfire. As the fuel travels to all of the cylinders, this leaves them all susceptible to misfires, as well as the...

Hi there. When it comes to alignments, check the Caster and Camber to your vehicle. These two angles are pulling angles. Keep in mind, most shops will set the Caster to allow the vehicle to drift to the left to...

Hi there - this is highly unusual behavior, and should be checked out immediately. Check for problem codes, even if the Check Engine light is not yet on. This is a misfire condition due to an over-rich condition (https://www.yourmechanic.com/question/car-backfires), possibly...

Diagnostic trouble code P0075 (https://www.yourmechanic.com/article/p0075-obd-ii-trouble-code-intake-valve-control-solenoid-circuit-bank-1-by-jay-safford) means there is a fault in the Intake Valve Control Solenoid Circuit. A defective solenoid is one possible cause of the code setting but problems in the circuit wiring are often the cause of the...

If it's a plastic under car cover, sometimes the area around the fastener will break through and then the cover drags on the ground. If you don't wait too long, the problem can be fixed by using large washers with...