Hi! I received a message on my instrument panel with a co...


Hi! I received a message on my instrument panel with a code A1234 Mechanic's Assistant: Just to clarify, what's the exact code? And have you tried to reset it? A1234 no I haven't. Mechanic's Assistant: What is the...

Hi! I received a message on my instrument panel with a code A1234 Mechanic's Assistant: Just to clarify, what's the exact code? And have you tried to reset it? A1234 no I haven't. Mechanic's Assistant: What is the make/model/year of your car? It's actually my wife's car.. 2013 Honda civic Mechanic's Assistant: Are you fixing your Civic yourself? What have you tried so far? Nothing yet. Need to know what the code is for first

Automotive Expert
Hello thank you for using just answer. Give me a moment to read over your question and I'll get back to you as soon as I can.
Automotive Expert
This is what I found. It's just your scheduled maintenance that you need. In the pictures see A start for oil change and one, two, three, and four applies to the other maintenance repairs.

not that there's anything wrong just recommended maintenance basically
Automotive Expert
Exactly. Each one turns on by mileage. Once the service complete the dealer or an auto repair shop will be able to clear those codes manually.

Thank you so much
Automotive Expert
You're welcome and thank you for using just answer.

What others are asking

The car has no electrical power at all
Hi. I would recommend to have a technician check for any loose power or ground wiring. There also could be some corrosion present that is blocking the electrical current flow. I also recommend that the technician use a test light to...
My alternator went out so I replaced it and also had put in new battery. Now it shuts off once I put it in drive.
Hi there. It would seem unusual, after replacing your vehicle alternator and battery, it would stall when put into drive. There is a possibility, the ECM (Engine Control Module) needs to relearn idle speed. Many vehicle engine computers have adaptive...
Very loud grinding on acceleration worse on turns
Hi there. Typically a bad motor mount will make a clunking sounds as the vehicle begins to accelerate or decelerate. The grinding sound while acceleration and turning is a common symptom of a bad or failing wheel bearing (https://www.yourmechanic.com/article/symptoms-of-bad-or-failing-wheel-bearings) as...
water not coming to the rediator, can it be a blown casket, peugeot diesel
Hello. If water is not flowing or going into the radiator then it may be possible that there is an issue with the cooling system. If water is not flowing then that may be a sign that the water pump...
Brown stuff coming from the radiator.
Hi there: If you have almost 600,000 miles on your Impala, it's probably time to replace your radiator (https://www.yourmechanic.com/services/radiator-replacement), as the brown stuff is likely rust coming from within your radiator due to excessive use.
Car shakes in idle and
Hi there. A rough idling engine can be caused by a number of issues, some of them are serious while others tend to be minor, but the symptoms remain pretty much the same. The car will feel rough and bouncy...
My car has a Maintenance alert with a "man icon" that just reads "Other." what does this mean? I have about 47k miles on it.
I went through all the possible icons in the owners manual and does not show an icon as you describe. I can only recommend you get the vehicle checked and scanned for problems and if you can send a picture...
Need to install new wiper switch on my 1966 chevelle SS
Hi Charles. Thanks for the question today. If I recall correctly, the wiper switch on the driver side of the dash does require removal of the dash, as I don't think you can access it from behind the firewall. It's...
My rpm gauge works only sometimes.
Since the engine is running okay then the computer is getting an rpm signal but the dash is not. This can be caused by a defective instrument cluster or the wiring connections and wiring to the cluster. The cluster will...