Skip the auto shop - Our mechanics make house calls

Q: Fuel rail injection pressure sensor

asked by on

I need to know where The few rail injection pressure sensor is located on my 2010 Acadia SLT. I need to know if it's located in the front of the motor in the back of the motor left or right-hand side of the motor. I just need help and details of the location. Thanks

My car has 140000 miles.
My car has an automatic transmission.

A: Hey there, thanks for writing in. It is in ...

Hey there, thanks for writing in. It is in the top center of the motor on the fuel rail. You have to remove the upper intake manifold to get to it.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Transmission uses oil and engine light is on. Why is it using oil in low and the transmission slips?

Hi there. If the transmission oil is low, then the transmission oil filter cannot pick up any fluid and cause the transmission to slip as the clutches are not able to apply. The Low application piston requires a mass amount...

Q: Fuel gauge not working right.

Hello. Sound like you are having several different issues. The fuel gauge is powered by a sending unit in the fuel tank. When you put fuel, a float rises with the fuel and depending on where it lands is the...

Q: Weird tapping sound when turning on heat or seat warmer.

It sounds like it could be the blower control module in the dash. It will be hard to get to and you should have a technician repair it.

Related articles

How to Renew Your Car Registration in Oklahoma(DELETED)
Having your car registered with the Oklahoma Tax Commission is an important part of driving legally in this state. You will need to do this within 30 days of moving to Oklahoma...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.