Q: Coast of changing the heater hose under the manifold got the parts

Hello. It sounds like the engine was not filled all the way. A lack of engine oil or a low engine oil level will cause the oil pressure to drop and can cause the engine to overheat as well. I...

Hello - You are correct that the torque sensor, or rather a bad torque sensor signal, is the cause of this problem. There is, however, a Ford Recall (Recall 14V284000) for this problem, so you don't have to do anything...

Hi...your vehicle has an on-board diagnostic system, albeit the early version known as OBD-I. What I would therefore recommend, to get this engine running condition diagnosed and repaired, is you request a check engine light diagnostic (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection). The trouble codes...

One common cause of such noise is a failed outer CV joint on the CV axle. If you peer behind each front wheel, underneath the vehicle, and use a very bright focused light to shine on the rubber boots that...

Hi There, It sounds like you definitely have a vacuum leak. High idle speed, stalling and hissing sounds are common signs of a vacuum leak. When a vacuum leak is present in an engine, this causes an excessive imbalance in...

Both engines that were used in the 2016 Tuscon were equipped with maintenance-free silent timing chain systems. Consequently, there is no recommended replacement (mileage) interval and, indeed, the timing chain could outlast the car unless the engine is abused. As...

If the car was out of coolant, and shut off because it was overheated, then there is a good chance that there was some engine damage. But don't panic yet, the codes and leaks you have might be separate issues...

You will need to replace the kinked hose to restore flow to the engine. This is the bypass hose so coolant flows through the engine before thermostat opens.