Q: Clutch release bearing gone

asked by on February 26, 2016

The clutch release bearing is gone.

The bearing will have to be replaced. I recommend having a reputable transmission handle this repair. I also suggest having the clutch and pressure plate replaced while they are in there. 

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Engine swap with Ej20x, Ecu question

I will describe a scenario that will work and you can then judge your actual circumstances based on that. The initial issue is not the "country of origin" but rather whether the block and heads are identical, in every respect,...

Should I replace my head gasket or just buy a new car?

Unfortunately, this is a decision you would need to make on your own. As you know, a blown head gasket can be very expensive to fix no matter the vehicle. This is not specific to a Subaru necessarily. As you...

Where can i find Crankshaft position location on my 2009 Acura TSX

The sensor is mounted to the engine block with a single bolt, mid way along the engine block under the exhaust manifold. The sensor is concealed beneath a cover that must be removed to gain access. You will see a...

I'm replacing a water pump in a Subaru Legacy. Do I need to use gasket sealant when replacing it? 1992 Subaru Legacy

Hi there - no, gasket sealer should not be required. the thermostat should come with an o-ring, and the water pump should come with a paper-like gasket. Neither should require gasket sealant as long as the o-ring and gasket are...

Do I need to remove the transmission to get to slave cylinder on Saturn Ion 2005?

Hi there. The slave cylinder is a part that is attached on the side of the transmission to operate the clutch fork. For your vehicle, the slave cylinder is inside the bell housing area. You can bleed the slave cylinder...

What type of ATF for ford fusion se 2009

Hi Sam. For the 2009 Ford Fusion, you'll want to use a Motorcraft Genuine Ford Fluid XT-10-QLVC MERCON-LV Automatic Transmission Fluid. You should purchase a service and repair manual for your Fusion for specific instructions on how to complete this...

Steering wheel and ignition locked up.

It sounds like you may have a problem with your key. If the key is excessively worn it will not be able to unlock the ignition cylinder so you can turn the key. I would ask for help from one...

Clutch lost all hydraulic pressure after difficulty engaging gears while using the clutch.

Hello. This situation is usually a failure of either the clutch master or slave cylinder - they simply wear out. If you have any clutch fluid on the drivers side front carpet, the failure is the clutch master cylinder. If...

Check Battery light still on

Hi. The system is not charging because of the symptoms mentioned. A new alternator does not always mean it is a good one. The wiring will need to be checked. There is a 150 amp fuse you can check. There...

Related articles

How to Troubleshoot a Slipping Clutch
There are numerous advantages to operating a vehicle with a manual transmission; many drivers claim it gives them more control over...
Top 10 PZEV Cars for Eco-Friendly Drivers
Teddy Leung / Shutterstock.com The whole idea of a PZEV (that is, a partial zero-emissions vehicle), seems paradoxical. You’d think it’d have to either be zero-emissions or not in the category at all. But as contradictory as...
How Long Does Clutch Fluid Last?
The The usual answer to this is, forever. Of course, as is the case with many hard and fast answers, there are always exceptions. The reason that your car clutch fluid should last forever is that it’s a closed system....