Second opinion] WHERE IS THE ABS SENSOR LOCATED ON THE RI...


Second opinion] WHERE IS THE ABS SENSOR LOCATED ON THE RIGHT REAT OF A 2015 DURAMAXJA: Okay, I'll connect you to the Mechanic to help find that for your car. Before I do, is there anything else you want him to know?Customer: NO ...

Second opinion] WHERE IS THE ABS SENSOR LOCATED ON THE RIGHT REAT OF A 2015 DURAMAXJA: Okay, I'll connect you to the Mechanic to help find that for your car. Before I do, is there anything else you want him to know?Customer: NO

Automotive Expert
Hi! My name is \*\*\*\*\* \*\*\*\*\* I will be able to assist you. I’m sorry that you’re having trouble with your vehicle. Don’t worry though, we’ll be able to figure this out. Thank you for taking the time to let us help you out with this problem and hopefully we can sort it out quickly. Please understand that I do not know your knowledge or capabilities so I may need to ask questions to find out basic information to help solve your specific problem. Sometimes it may take a moment for me to respond because I may have to look up information about your concern. I appreciate your patience and will provide responses as soon as possible. The rear wheel speed sensor is bolted to the back of the axle housing behind the brake rotor. My goal is to give you the best service possible and to help you. If you have any questions or concerns, please don’t hesitate to let me know. If I’m not online at the time, I will respond ASAP when I get back.

The guy did not know what is was taking about!!! It takes too long to get answer. And then the answer is wrong!!!I will let all my friends no not to use this sight!
Automotive Expert
I can double check it. Is it 2wd or 4wd? 3/4 or 1 ton?

What others are asking

What determines if the air bags will deploy or not?
While it might seem like your air bags should deploy during every accident, that’s actually not the case. Some aren’t severe enough to warrant it, while in other situations, deploying the air bags might actually cause injury if someone isn’t...
All four brakes locking up after being driven for about 45 minutes
Hi there, if work was recently done on the master cylinder or brake booster, check to see if the brake push rod (manual or power assisted) has too little free play. If it is too tight, the master cylinder piston...
Engine does not turn over
Hello. The symptoms you describe are commonly caused by issues with the battery or starting system. If the battery runs low it will not have enough power to crank the engine, which may result in an engine that does not...
why won't my overdrive work
Hi there. The overdrive clutches in the transmission could be slipping causing the transmission not to shift into overdrive. I recommend seeking out a professional, such as one from Your Mechanic, to help you diagnose your transmission (https://www.yourmechanic.com/services/gears-slipping-when-accelerating-inspection).
What causes me car to be weak when going uphill
There may be a few different reasons for a vehicle to not have power to go up a hill. You need to first determine if it is the engine or transmission problem. If the transmission is not downshifting or is...
Is there another car i can use bushings off of? Can't find my cars bushing for lower control arms 1999 Mitsubishi Diamante
Hi there - on this specific model, the bushing is pre-installed in the control arm by suppliers. For aluminum control arms (https://www.yourmechanic.com/article/how-to-buy-a-good-quality-control-arm-assembly) such as this one, it is generally not a good idea to field-repair the control arm. The act...
Cost for to replace the rear camshaft seal.
Billing question sent to CS for the cost of replacing the camshaft seal on a 2005 Kia Amanti with a V6-3.5L engine.
Vehicle shakes during acceleration
Among the remaining possibilities are defective motor mounts, struts, and engine operating condition (the engine needs to be looked at with a scope under load and a compression test might be helpful, too). If there is no problem with the...
I just installed a new fuel pump on my 1995 f150 xl.. I had thought the pump was bad.. But come to find out that there is no power
Hi Micah. Thanks for contacting us today. Typically, when you have an issue like this, it's caused by either an exposed electrical wire that is creating a short or a blown fuse/relay. The best advice I can offer is for...