Q: Blend doors not working properly.

asked by on

I have cold air blowing out the driver's side, and hot air blowing out the passenger's side. I am assuming that either the left or right blend door is not working properly.

Thank you for your inquiry. Your assumptions are very close, especially if your vehicle has a dual-zone system where the driver and passenger can enjoy different temperatures. Have a certified mechanic, like the ones at YourMechanic, inspect the system and perform the appropriate repairs.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Blend doors not working properly.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: hot air blows out driver side vents but only cold air out passenger side vents?

Hello, thanks for writing in about your Toyota 4Runner. Your A/C has separate temperature control actuators on the A/C evaporator case and the passenger side one may be stuck in cold position. Replace the actuator and it should fix the...

Q: My oil light does not come on when the oil is low, and the heater only blows hot air for a short time.

When the oil pressure drops lower than 8 psi, then the oil light will come on. If the oil pressure drops and there is no light, then check the oil pressure sensor harness for power. If there is power, then...

Q: Car filling up with water when it rains

Depending on where the water is located you could have a leak in a weatherstrip seal on a door or trunk, a windshield, or the rear glass. There are instances where the weather stripping on the body panels fail. There...

Related articles

What Causes Hoses to Leak?
While the largest part of your engine is mechanical, hydraulics plays a significant role. You’ll find fluids at work in a number of different areas. Your car's fluids include: Engine oil Transmission...
How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...