Q: Banging sound at slow speed at left rear wheel well area

asked by on December 21, 2016

My car has 8000 miles.
My car has an automatic transmission.

Hi there. Raise up the vehicle and check all of the suspension, sway bar, ball joints, and the shock absorbers. Makes sure that everything is tight. If everything is tight, lower the vehicle and do a bounce test on the rear. Also, check the ride height on the rear of the vehicle. It is possible that the rear springs could be the wrong spring for the vehicle causing the rear axle bumps stops to come in contact with the frame. If the springs are tight, then something within the suspension is binding up or a caliper is loose causing the popping noise. If you need further assistance with your vehicle making noises on bumps, then seek out a professional, such as one from Your Mechanic, to help you.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Where is the thermostat on a 2008 dodge nitro 4.0l

Hello, thank you for writing in. The thermostat is located under the coolant reservoir at the front of the vehicle. There are diagrams available in the service manual. To start the process you need to access the thermostat. This is...

Can a manual adjusted driver seat be raised in the 2016 dodge Durango

Manual seats on this vehicle model have no height adjustment. The height is fixed. Only the optional power seats can be moved up or down. The rental car agency may have special purpose cushions to assist you and/or you might...

Replaced water pump and now it makes a loud roaring noise when accelerating

What you are describing sounds like a fan clutch that may be wearing out. A mechanical fan clutch works by helping to control the radiator cooling fan speeds as the engine heats up and cools down. As the motor heats...

Overcharging 18volts +

The shop was correct about how the ECU controls the field current of the alternator which will cause the alternator to charge the batteries. If the wire on pin 57, the dark green with orange stripe wire at the ECU,...

2010 Dodge Journey shakes in gear during idle

Hi Margarito. In most cases, when your car is vibrating at idle or slow speeds while in gear, it's caused by a vacuum leak, loose motor mounts or in some instances, a worn out CV joint on the front end....

ASD relay not activating

Hello. If you require an accurate wiring diagram you will be able to find one in the vehicle's service manual, or a quality repair manual. You may also be able to acquire the diagrams through a dealership or shop, or...

Torn lower ball joints and torn tie rods - 2006 Nissan Sentra

Hi there. Unfortunately, diagnosing what type of service may have been performed by a different mechanic without physically inspecting the vehicle is difficult, as is knowing how long your vehicle can be driven with worn out ball joints and tie...

Engine turns over but won't start. Could it be a sensor and how do I check?

Hi there. There is a possibility that no power is being supplied from the ignition switch to the power distribution center fuse. The ASD relay fuse may have blown on the ground "control" side of ASD relay. Circuit tests need...

I may have put the wrong type oil in my car?

Your engine does not show in the manual that it is required to use only full synthetic oil. You can use the synthetic blend or conventional type oils as long as you use the correct weight oil that is recommended...

Related articles

What Are the Dangers of Driving a Vehicle With a Broken Suspension?
Every car, truck, and SUV has a suspension, the collection of parts that holds the car off the ground, cushions passengers and cargo from bumps,...
What Are the Dangers of Lowering My Car?
It It has become fairly common for car owners to modify their cars’ suspensions to make their car ride lower. Usually aesthetics are one of the most important reasons for reducing ride height — many people prefer the appearance of...
How Long Do Stabilizer Bar Bushings Last?
A A stabilizer bar is pretty much exactly what it sounds like – a metal bar that helps to stabilize your car. It plays a significant role in handling, particularly around sharp turns. The bar’s job is pretty simple. It...