Q: Bad clutch
Clutch went out.
Recommended Services
| Clutch is not working Inspection | $94.99 - $114.99 | Get a Quote |
If the clutch is slipping, then a new clutch will most likely need to be installed. The flywheel will need to be inspected and possibly machined, if there are gouges or hotspots. You may want to enlist the help of a mechanic to help diagnose, and commence in clutch repairs.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Jeep starts, but turns off
Hello. This is a fairly common problem which can be checked several ways. First, turn the key off, get out of the car, then turn on alarm/security, which should lock the car door. Wait 2 minutes, unlock the security control...
Occasional shaking and sluggishness while accelerating
If your vehicle is shaking and losing power, the most likely cause is fuel or ignition system related. I would recommend having the fuel pressure checked by a qualified professional to determine whether or not the fuel pressure is within...
What wires do I connect to the starter
The black and orange striped wire goes with the red wires behind nut with the big starter cable. The small, tan and red striped one goes to the small terminal. If you are still having trouble, a technician from YourMechanic...
The cam chain snapped. Is the engine on a 2011 Ford Transit 2.4L a non-interference engine?
Hello and thank you for contacting Your Mechanic. The engine in your ford 2011 is a tdci diesel 2.4 engine. The engine is an interference engine and the valve train could be damaged. Install the new chain on the camshaft...
Clicking sound.
This is likely a problem with something on your starter called a starter solenoid. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. As electricity is supplied to the starter...
tool name
Most vehicle seat covers are held onto the seat with hog rings. These rings can be removed and installed with a pair of hog ring pliers. These can be found online or at your local hardware store. It is also...
Brake lines underneath car are wet?
Corrosion on brake lines ultimately results in burst failures due to the high pressure on these lines which is measured in many hundreds of pounds per square inch. The decision on how much brake line to replace, and which lines,...
Can a bad o2 sensor cause my vehicle to jerk and jolt while driving?
It's "possible" but if the oxygen sensor(s) were bad enough to cause such symptoms, the check engine light would be on and there would be a diagnostic trouble code referencing an oxygen sensor or sensor circuit fault. In any event,...
I recently replace all my tires, once i get to about 50 mph my car shakes and the steering wheel shakes badly. what can it be. Som
If the problems all started after the tires were replaced then you may have had a weight come off or the tires are not balanced correctly. Have the tires rechecked by the installer to verify the tires are ok and...
Related articles
Symptoms of a Bad or Failing Clutch Cable Adjuster
Common signs include difficulty disengaging, loose clutch pedal, and an excessively tight clutch cable.
Symptoms of a Bad or Failing Fan Clutch
If your car has a fan clutch, common signs include the vehicle overheating, the cooling fans working very loudly, or engine performance decreasing.
How to Troubleshoot a Clutch Pedal Sticking to the Floor
Clutch pedals in manual cars stay on the floor if there's a failed clutch release bearing, slave cylinder, clutch master cylinder, or clutch linkage.
Browse other content
Estimates
Maintenance