Q: 2012 Sonic on Startup sounds like grinding metal against metal coming from Turbo area

Hello there, a few different faults can cause the AC clutch not to engage on your 1998 Nissan 200SX. The most common would be the refrigerant is low (https://www.yourmechanic.com/services/ac-recharge), AC high pressure switch (https://www.yourmechanic.com/services/ac-pressure-switch-replacement), AC clutch failure, or lack of...

You could possibly be covered under recall 12V222000 for the leaking power steering line leaking on to the exhaust. The leak can be a fire hazard and covered vehicles will have the leaking pressure line replaced. You should call your...

Hello. My research indicates that those two different model years of Dakota use two different models of transfer case, as indicated by their part numbers. This means that they are likely different and are not cross compatible. Depending on what...

Hi there. In a manual transmission, a flywheel is attached to the engine crankshaft and spins with it. A clutch disk is located between the pressure plate and the flywheel, which is held against the flywheel due to pressure from...

Check the ground wires on the back of the vehicle as they are either broke or loose. Over time the bolt that holds the ground wire to the frame tends to become rusty causing the ground to have a high...

If you want to use an OBD-II controlled engine (2001 versus 1993), you will have to completely replace the entire electrical system on your 1993 324i (i.e., use only the 2001 model year electrical system and computers). The engine computers...

Hi there. What you are describing is typically an indication a broken or cracked exhaust manifold or exhaust pipe downstream. The exhaust systems on cars, trucks and SUV's are finely tuned to expel exhaust gases from the combustion chamber and...

Moisture in the air (water vapor) can condense in the engine and contaminate the oil. The amounts are typically not significant and the water eventually vaporizes in hot operation and leaves the engine. The other source of water is from...

Code P0011 is most commonly caused by the solenoid or cam sensor. I would recommend replacing the solenoid first and then cam sensor.