Q: 2005 Mercedes-Benz Sprinter 2500

asked by on September 03, 2016

My Check Engine Light has been on for awhile and it doesn’t turn off. I get the code for three and four glow plug, as well as the crank sensor. I replaced those, but the Check Engine Light is still on. Can you help me figure out what’s wrong?

The Check Engine light must be reset by a Scan/Clear tool that supports the Sprinter. The computer will not reset it on its own.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

What could be wrong with my car if the wheel is hard to turn while driving? I put power steering fluid in the car.

There can be many different possible causes of hard power steering. The most common things to check for are a broken power steering pump belt, or a leak that has caused the pump to run out of fluid. A power...

My 2001 c320 has an intermittent starting problem. I turn the key to start the car and nothing. There is no engine turn over. All

A YourMechanic no start diagnostic on the problem you have written in about involves first determining whether or not full battery voltage is reaching the starter motor itself. If not, then the circuit has to be traced from the battery...

Car won't start or stay in park.

Hi there. The issue could be the shifter cable not adjusted properly or the transmission position sensor could have failed. If the transmission is not shifting into park, then check the shifter cable to see if its loose on the...

Am I safe to continue driving if my steering is off and check engine light is on?

When the steering is concerned, the issues should be taken seriously. Driving without the assistance of power steering is very difficult if the steering fails. If going at high speeds you may not be able to correct in time to...

2054 fault code

Hello. The code you are getting is for what is known as the PremAir sensor. This is the ozone air detection sensor. They are a common failure on this vehicle. The sensor can usually be tested with a scan tool...

Engine Fuse Box

Yes, you should replace the entire fuse box. The reason for this is that it is quite likely that when the box burned other connections inside the fuse box were also damaged. This will in fact affect the vehicle starting...

Transmission leak stuck choppy - 2005 Mercedes Benz C55 AMG

Hello. From the symptoms you describe, it would appear that the vehicle is experiencing issues that have put it into limp, power reduction mode. If the TCU requires replacement, it can usually be found in the engine bay on the...

What does the headlight control sensor do?

If your car has automatic headlights, then it also has a headlight control sensor. Essentially, this is what’s responsible for turning your headlights on and off based on ambient light levels. The sensor is located on the dash near the...

Carbon canister making a loud hissing noise.

Hi there. The loud hissing noise could be caused by a split vacuum hose or a loose hose. Follow the hiss to make sure it is the canister and not a separate hose. The code stored for the Check Engine...

Related articles

How Do Sensors Get Dirty or Damaged?
Car sensors measure and relay vital information to the ECU. Some sensors can get dirty from normal use, or fail if the car overheats or has a problem.
P2344 OBD-II Trouble Code: Cylinder #9 Above Knock Threshold
P2344 means an issue with the cylinder 9 knock sensor circuit. Some causes are faulty knock sensor, damaged wires, and cylinder firing malfunctions.
P0709 OBD-II Trouble Code: Transmission Range Sensor Circuit Malfunction
P0709 P0709 code definition The P0709 code is known as Transmission Range Sensor Circuit Intermittent. What the P0709 code means The meaning of P0709 varies slightly among makes and models, but in general, this code indicates that the PCM (powertrain...