Q: 2002 s430 mb, code p0444,how many purge control valves and location?

asked by on

check engine code p0444

There are 2 purge control valves. The rear valve is located in the rear wheel well (driver side) behind the wheel well panel. The front valve is located next to the ABS unit (driver side) in the engine compartment.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. 2002 s430 mb, code p0444,how many purge control valves and location?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: The car battery doesn't seem to be charging I replace the alternator and the battery the car runs for about 10 minutes and everyth

This may be related to a failing voltage regulator or potentially a bad ground connection. As you may know, the voltage regulator regulates the amount of charging the alternator provides to the battery. When this is not working correctly, this...

Q: After valve cover gasket replacement, compressor broke

Hi there. Thanks for writing in about your 2000 Lexus GS400. Compressors can go bad due to oil saturation. It is likely that the technician spilled additional oil on the compressor when replacing the valve cover. The technician may have...

Q: Car is burning antifreeze

If your car is overheating, smelling like coolant, and always in need of coolant, then those are signs that you may have a coolant leak somewhere. The smoke you are seeing may be antifreeze leaking out onto hot parts of...

Related articles

How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.