The purge valve is mounted on the engine and you will see hose connections from the valve to the intake manifold as well as a wire harness connection. The purge valve should be tested to determine if it is actually...
Billing question was sent to CS for the cost of labor to install a canister purge valve in the fuel system on a 2010 Ford Fusion with a 4L-2.5L engine.
Hi there. The issue that you are having is the purge valve (https://www.yourmechanic.com/services/canister-purge-solenoid-replacement) on the fuel system is not functioning correctly and needs check and possibly replaced. The code P0600 is referring that the dash is not communicating to the...
In the EVAP system, the purge valve and the vent control valve are separate parts with different functions. If the gas mileage you are getting is very low, there is probably a fault in addition to the EVAP system fault....
The purge valve on the engine is not supposed to flow fuel tank vapors from the carbon canister when the vehicle is off or at idle. When refueling the vehicle a lot of fumes are generated in the tank and...
Hi there. There could be an electrical issue with the cluster panel on the dash causing the gauge to malfunction. For the fuel smell, there could be a vapor fuel line that is cracked under the vehicle or the purge...
The canister purge valve is generally located under the hood of the vehicle. The canister purge valve may be bolted to the engine intake manifold or near the intake manifold with an emissions pipe attached to it. Consider hiring the...
Hi and thanks for contacting YourMechanic. There could be a vacuum leak at the purge valve or around the purge valve. Look to see if the gas cap closed properly, there is no cracks or other damage on the charcoal...
The most common cause for this hard or no start after getting fuel is the purge valve is leaking fumes to the engine while fueling the vehicle. You should first have any computer codes checked by scanning the computer and...
The purge valve is most likely leaking fumes into the intake manifold when your are refuelling the vehicle. This will flood the engine with gas fumes and cause the hard start and run rough until the excess fumes are burned...
You must have a leaking purge valve that is letting fumes that build up in the fuel tank when refueling the truck. Have the purge valve checked by applying vacuum to purge valve with the engine off to see if...
The code P147d is coming up for the fuel canister purge valve (https://www.yourmechanic.com/services/canister-purge-solenoid-replacement) that could be sticking and not working properly. The purge valve is designed to control the emission's vapors in the fuel system. If the valve is not...
If you are getting codes to the vent solenoid and cannot command it open with the scanner then you need to see if scanner said it is open or closed. Then test the resistance of the solenoid for specified resistance....
If you have a large emission system leak the best way to find the leak is to do a smoke test and put smoke pressure in the fuel tank and it will show the smoke out of the system leak....
Hi there. There are two different locations that the purge valve was located at, depending on the vehicle type. The first location would be on the engine intake next to the throttle body on the left side when viewing the...
Hi there. The purge control valve on your vehicle should be behind the engine air filter housing. You may have to remove the air filter housing to get to the purge valve. The valve is held on by a couple...
Hey there. The main issue with not repairing the EVAP system is that of passing an emissions test as required in most states. Anytime this system is not working properly, your car will not pass an emissions test. The other...
