Q: Putting gas in a 2009 ford f150 and it won't crank after

asked by on February 25, 2017

Putting fuel in a 2009 ford f150 and it won't crank until i hold gas pedal down

You must have a leaking purge valve that is letting fumes that build up in the fuel tank when refueling the truck. Have the purge valve checked by applying vacuum to purge valve with the engine off to see if it can hold vacuum. If it cannot then replace the purge valve and it will fix the problem.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

When Should Engine Hoses be Replaced?
Regularly scheduled maintenance of hoses varies between vehicle manufacturers, but a good rule of thumb is to replace them whenever you have the cooling system serviced (cooling system flushed) or at 100,000 miles. In the years past, hose technology was...
What does the Intelligent Key detection Warning Light mean?
The Intelligent Key detection Warning Light is located on the instrument panel. This light can illuminate for two reasons: 1. The Intelligent Key is left outside of the vehicle when the ignition switch is moved to ACC or ON. 2....
How do I use the headlight aiming control?
If you have a lot of weight in your vehicle, or are traveling up a steep hill, the headlights may be angled too high. This can cause visibility issues for not only you, but also any vehicle in front of...
Traction Control light on, crumbling at the front end
This vehicle has many technical bulletins that pertains to wiring issues with pins and connectors to various modules and control units (https://www.yourmechanic.com/article/what-is-a-vehicle-s-electrical-control-unit) in the vehicle. This issue is one that is hard to track down, since it is an intermittent...
Car won't start, engine ticking
Hello. It sounds like the battery is weak and does not have enough power to start the car. Even though the lights come on in the dashboard, it does not mean that there are enough volts for the battery to...
I have a blinking drive light on my 2004 honda crv. The transmission oil has been changed and there are no shif ting problems.
This could be a variety of possibilities and if there are not shifting problems, this may suggest something as simple as a faulty sensor. I would suggest having an expert from YourMechanic come to your home to diagnose with a...
When I turn on the AC, the malfunction light comes on and the car doesn't accelerate well and starts jerking.
The trouble code stored in the vehicles computer may shed some light on what's going on. Turning on the AC adds an extra load to the engine and the computer picked up some trouble when the data figures changed. Consider...
i have a knocking noise coming from under my feet on driver side by the tire and its a bottom knock right under the gas and brakes
Hi there. If your vehicle is a front wheel drive, then the noise could be a CV Shaft failing causing the knocking noise. If your vehicle is a 4x4, then the front driveshaft universal joints are worn and making the...
how much do you think my annual maintenance costs will be for a 2017 BMW 230i for the first five years?
Hello. You should have the first few years covered as far as maintenance goes. Once it is out of the free schedules maintenance it should run you about $500 per year based on the recommended schedule. If you drive more...

Related articles

How to Replace an Evaporative Emission Control Canister
Emissions are regulated by the EVAP emission control canister which fails when the fuel tank gauge does not work or you fail an emissions test.
How to Clean Evaporator Drain Tubes
The air conditioning system on a car has evaporator drain tubes than need cleaning if there is dirty air in the car or it is not blowing consistently.
How to Replace a Canister Purge Solenoid
The canister purge solenoid prevents harmful vapor from releasing into the atmosphere. A faulty solenoid will not allow you to pass an emissions test.