Hi, I have ran across this many times on this vehicle. The most common cause of this is a bad connection at the wiper motor. There is a common issue with the terminals either coming loose or melting causing a...
Check the voltage at the battery terminals for 12 volts at rest. While cranking the voltage shouldn't drop very much, about 10 volts. Jump the vehicle and observe the voltage while it's running. If the voltage isn't above 13.5 volts,...
Hello. It sounds like you are experiencing either an ignition timing problem or an issue with the carburetor. Most of the time if the engine runs fine at higher speeds, this is caused by a carburetor issue. The throttle plates...
It sounds like what you are describing may be related to a faulty starter relay or some faulty wiring that may not be producing a proper connection to the starter. The starter relay (https://www.yourmechanic.com/services/starter-relay-replacement) directs power from the battery to...
Hi there. Alert chimes are triggered by sensors located on doors, seat belts and other devices that alert a driver that something is either open or not properly secured. To determine why they are not working correctly, have a mechanic...
Hi there. Understanding what causes the transmission hot idle warning light is critical to diagnosing your problem. The Transmission Hot – Idle Engine message can be displayed when the transmission fluid is too hot, which prevents the transmission from cooling...
The powertrain control module (PCM) sends the mass air flow (MAF) sensor a 12-volt reference signal. Incoming air flows over a wire inside the MAF, which allows it to measure intake air temperature, and therefore air density. The MAF then...
Hi there. It seems that there could be a head gasket or intake manifold gasket is leaking causing coolant to enter the combustion chamber make the white smoke and the engine to have a popping noise. Also, since you have...
Hi Chuck. That really depends on your tools, equipment and experience. Some professional mechanics with engine lifts and air tools can remove the accessories, motor and transmission mounts in less than two hours. The best advice I can offer is...
Hi there. Check the electrical wiring to the transfer case shifter motor and see if there is a voltage present when pushing on the 4WD button. If there is a voltage present, then I recommend replacing the servo motor on...
Your engine is getting coolant into it and producing the white smoke out the tail pipe. The coolant could be getting into the motor from the intake, head gaskets, or head crack. The system would need to be checked to...
Hi there. Check the battery cables and make sure that they are tight and clean. Check the cables that attach to the starter and make sure that they are all tight and clean. The starter remote wire could have an...
Hello. We will be happy to assist you. There are are a few things that I recommend a technician inspect. Fuel should have been inside the filter once you removed it. A test must be done to see if the...
The remote start may not activate if the systems show there is not a correct condition for the remote start to activate. If there is a problem in the body control module security system that may be a problem in...
Hi there. The P0708 trouble code (https://www.yourmechanic.com/article/p0708-obd-ii-trouble-code-transmission-range-sensor-circuit-high-input-by-andrew-quinn) means that the Engine Control Module (ECM) has detected a malfunction with the transmission range sensor. A mechanic would begin the diagnosis of the P0708 trouble code by finding the manufacturer’s suggested procedure...
If the coolant level was low due to a leak, such leaks can be found during a leak diagnostic with simple pressure testing. If the cooling system doesn't maintain pressure, and no external leak is visible, coolant could be leaking...
The 5.9L diesel is a straight six engine. The 6.6L diesel and the 7.3L diesel are both V8 engines. If find that there are more maintenance when it comes to the V-configured engines to the straight six engines. I have...
Hi there. Sounds like the shifter module motor or shifter rail is not working properly. Check the wiring on the shifter module motor on the transfer case and see if the wires are split or damaged. If the wires are...
Hello. I would need to know what code you are getting to know what needs to be done to take care of this. If you are getting a MAF code then the sensor may be failing, but that will not...
You need to have the cooling system fan clutch checked to see if it is keeping the fan running high speed even when cold. With engine idling with the engine cold you should have very low air flow from the...
