Popular questions

It sounds like you may have a faulty engine or transmission mount. These mounts are what secures the engine or transmission to the frame of the vehicle. These mounts are made of metal frames with large solid pieces of rubber...

Hi there - I believe you meant Electronic Stability Control module. ESC works somewhat like anti-skid brakes, applying selective brake pulses automatically in extreme cornering situations to improve driver control of the vehicle. It is somewhat unusual for the ECS...

You won't know until you get the brake caliper off. If it is a brake problem, the caliper will be very difficult to remove but the hub will turn freely after you get it off. That could be a parking...

You should first have the computer system tested so the noise can be completely diagnosed to find the cause of cold start rattling noise. You may just need to replace cam phaser or timing chain and guides with the phasers....

This may be related to a dirty or failing idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at...

The transmission seems to be slipping internally. The 3-4 clutches are most likely bad, causing the transmission to slip. The transmission would likely need to be overhauled or replaced. I recommend that you have a mechanic, like the ones from...

Your Accord features a number of convenience lights designed to make it easier to see inside your car in low-light situations. The ceiling light (also called a dome light) is one of these. It has three settings here: On...

Hello, being that the power door locks are controlled by the body control module, a scanner needs to be connected to see if there are any codes present. Also, with a scanner connected, there might be inputs that can be...

As with any car, the life expectancy depends largely on how you maintain the car, the driving conditions it is subjected to, the driving habits of the owner and many other factors. Proper maintenance schedules are a key factor to...

When I replace a hub, I don't necessarily remove the CV joints. I do, however, remove the nut that is holding the CV joint onto the hub. You will need to remove the brakes and rotor, the upper and lower...

The trouble code P0405 is for the EGR sensor. This code indicates that the sensor is not giving correct voltage readings. You'll need to replace the sensor and the sensor hoses. The hoses can clog or burn through which causes...

Hi there. There are multiple things that could be the problem; the door switch, latch assembly, latch position, wire harness, door ajar switch, body ECU (BCM), etc. Before replacing any parts, I suggest having a qualified technician perform an inspection....

The message is on for the lights are not completing a circuit from the switch to the lights. Check all of the wiring on the lights and see if all of them are plugged in properly. Then look for any...

The second gear synchronizer is usually the first one to fail in a manual transmission. The synchronizers are devices in the transmission that match the speed of the gears before allowing them to mesh. It's that downshift to second gear...

You will find it on the passenger side rear of the engine. It's a little tough to get to unless on a vehicle lift.

If you went to a service center, in all probability the work that they performed is covered under a warranty of some sort. Additionally, if you paid by credit card, for sure you are covered if you have encountered a...

I an sorry to hand you this news, but a loud boom followed by a stalled engine and smoke is not a very good sign. If the engine failed while low on oil and overheating at the same time, I...

Hi there. The transmission may have burnt clutches in the overdrive clutch pack. The solenoids for this transmission would not go out without effecting more gears. Check the fluid to the transmission and see if it is dark red or...

The brake pedal should stay up hard when you have the engine off. As long as you do not see any loss of fluid after system is bled out of any air in the system. You may need to have...

The seat belt pretensioners are a key part of the front seat safety system. The pretensioners help the belts restrain the driver and front passenger quickly in the event of an accident. The pretensioners can only be used once, so...

Changing out parts for the no start may lead to replacing the correct part, but it may take a few parts and money. I suggest having a qualified mechanic come and diagnose the no start by checking fuel pressures or...

This might be a problem with the theft deterrent system, if you have another key you might try using that, otherwise you might need a certified mechanic to scan for engine codes and verify that the oil pressure switch is...

Hello. The traction light and ABS light are like a check engine light for your braking system. If an issue is detected the light will illuminate and code will be stored inside of the ABS module. I suggest that a...

Hello, if the shifter is disconnected, there is a chance that what ever holds the cable to the linkage is broken or worn out. The cable where it has become disconnected should be inspected to see what has failed. I...