Popular questions

Hello - both of these sensors are "pre-catalytic converter" or in front of the cats in the exhaust stream (P0152/P0132). This is what the "Sensor 1" portion of the problem code means. I recommend an oxygen sensor replacement service performed...

If they just put 2 new axles in, I would certainly take it back and ask them about it. What you're describing sounds like a CV type noise There are a great many companies remanufacturing axles for the service market,...

It needs to be determined where the leak is coming from. Is it engine oil? Power steering fluid? Transmission fluid? Some leaks are easy fixes, some can be quite expensive. A qualified mechanic from YourMechanic can come out and diagnose...

The valvetronic motor is stuck or not functioning properly and causing the engine to not start up. I recommend replacing the valvetronic motor. The motor is designed to cycle itself when turning on the ignition, so it is good to...

Hi Tony. Thanks for contacting us tonight. A thermostat housing and water pump are not always the root sources of overheating issues. In fact, quite often, even if they are damaged, additional cooling system problems can occur, such as obstruction...

Hi there. The computer to the transmission (TCS) has failed and is not responding to any sensors and solenoids. When the TCS fails, it shuts off power to the transmission putting it into a limp mode as if the harness...

With the symptoms you have described, the most likely cause is a leak in the clutch hydraulic system. If there is a leak on the system it causes air to enter. Since air is not able to be compressed the...

It is pretty common to hear the window motor running without the window coming up. This is very common, most of the time a power window regulator is at fault. The regulator includes the channel, frame cable pulleys, etc., which...

You should check to make sure the starter bolts did not come loose and remove the lower inspection cover for transmission and check to see if flywheel teeth are damaged or flywheel is loose or bolts for torque converter are...

There are 6 different 2.0 motors for this year and they all may be different timing procedures and you would need to supply the 8th digit of your VIN in order to get the correct engine and timing procedure to...

It is possible that the noise and "no power" symptom you experience is the exhaust pressure in the turbocharger of your engine being released. In some cases, an excessively rich mixture of fumes in the exhaust is ignited causing a...

Hello. A brake pedal going to the floor is a sign of a bad master cylinder or leaking hydraulic fluid. I suggest having the brake system inspected by a technician. Preferably a technician who is ASE certified in brakes because...

Hello. Most of the time this is caused by the lift motor failing. The motor will lose its ability to lift the top, which will cause all of these symptoms. It can also be an electrical issue, but this is...

Hi there: Different mechanics and automotive retailers have unique service checks before selling a car or saying that it's "OK" to sell. So it's virtually impossible for us to tell you whether or not the bad bushing should have been...

Hi there. I would highly recommend having one of our professional mobile mechanics come to your location and complete an AC is not working inspection, before attempting further diagnosis. There are several possible reasons why you might be having these...

Clean any debris on the battery posts using a mixture of baking soda and water. Under your battery is a pedal that connects to the PCM. Make sure that it is pushed down hard so that your battery does not...

The carburetor may need to be rebuilt or adjusted. The EGR system may also be causing the rough idle due to the EGR partly stuck open. The only way to isolate which one is causing the issue would be to...

Hi there. Typically calling your local Hyundai service department is the best way to resolve this issue, but I did find this video and most Hyundai's have similar steps for changing language settings.

The P0101 code may be related to many other things aside from the mass air flow sensor such as: intake air leaks, dirty mass air filter, an open or shorted MAF sensor harness, or a poor connection involved with the...

Hi there, thanks for your question. Yes, these older Chevys do have full time four-wheel drive. There are kits available that will disengage the differential from the transfer case, but I've heard mixed reviews on how well they work. You...

The most likely cause is that the clutch slave cylinder at the transmission is leaking. The leak would be coming from the transmission bellhousing at the bottom, if this is the case. The transmission clutch line from the clutch master...

Hi and thanks for the question - it is a good one. Modern cooling systems work under different pressures and with so many hoses and auxiliary water pumps it can be hard to find a coolant leak. Factor in that...

Your floor mats provide protection for the carpeting under your feet, and the mats used in your vehicle have a special design. They’re what are called positive retention floor mats. They use a hook system to keep them in place...

The only common issue I found for the rear suspension is that the rear axle joints are prone to failure. Other than that problem there are no recalls or bulletins for anything else. If the problem was an axle then...