Popular questions

Hi. Some of the codes you have will cause drivability problems and may cause the van not to start. The code p0118 deals with your coolant temperature sensor and a bad coolant temperature sensor will cause the car not to...

Hi and thanks for contacting YourMechanic. Check the manifold absolute pressure (MAP) sensor for any corrosion or burned pins. This is what the P0107 code is coming up for. Check for power to the sensor. Back probe the wires and...

Hi there. Typically when your car is consuming this amount of oil at an incredible rate, it's caused by an internal engine fault, such as damaged cylinder head valve guides or piston rings.Although our mobile mechanics can often complete routine...

A common cause of a noise like that is tire belt (internal) separation, flat spot(s) on tire or other tire defects. If the tires end up being excluded during a diagnostic, the CV axles, wheel bearings, and unfortunately the transmission...

If you have replaced your battery four times since 2012 then you are having an issue with your charging system that should be diagnosed. There are a few Technical Service Bulletins(TSB) that could address your issue. The first two are...

The engine shuts down in drive because once in drive the transmission places a load on the engine and obviously the engine's operation is marginal enough that it can't accommodate that load. The engine has an ignition, fuel, or air...

Hello there. It sounds like you have a cloud of things going on with your Hyundai XG300. If the alternator is overcharging the battery, then there is a good chance the alternator has failed. Most of the time, this is...

The noise you are describing has to originate from the rear axle, differential, suspension or brakes. You are describing a fairly distinct and easily reproducible noise and inasmuch as there really are limited possibilities, particularly if yo have isolated it...

Harsh gear engagement is due to an internal transmission fault. Among the possible scenarios are internal hydraulic leaks, or out of range line pressure. Hydraulic force is what effects shifting and if the "force" is delayed, too high, or applied...

Hi there. There are multiple potential causes of your engine's "cough". The engine that powers your 2007 Honda City has multiple sensors that help the fuel system burn fuel efficiently. Since your fuel efficiency mileage is also suffering, my...

If this failure to shift into gear occurred immediately after battery replacement, somehow the removal and re-application of power to the shift interlock has caused a malfunction. Check to see if the brake lights come on. The brake light switch...

Hey there. If you have a "chip key", try replacing it and re-programming to recognize the new key. Sometimes the keys will develop faults. If it is not the key, there is a specific Diagnostic Procedure for this issue in...

The sensor is held in place by a spring steel clip. Normally, pliers are needed to pry the retaining clip out. The new sensor should seat square to the bore in the cylinder head. If the sensor is sitting square...

If the starter sounds weak when the key is turned, it is likely that the battery was low on charge or the starter is actually getting weak. I would recommend having the battery voltage level tested during a starting sequence....

Hi there. From the description you have given, the drivability problem your vehicle has may be a fuel delivery problem. This would account for your vehicle not wanting to start that one day. Next day, you were entering the highway...

The ambient air temperature sensor is located in front of the a/c condenser in the center of the vehicle mounted just below the hood latch on the support bracket. The sensor will give temperature reading s from about -40 to...

Hi there. Use a diagnostic tool and check the data from the steering angle sensor. See if the steering angle changes and the wheel velocity is displayed when the steering wheel is moved. If no change, then the steering angle...

When you look at the brake pads on the right side, if both the inner and outer pads are worn then you have a caliper piston sticking or the brake hose holding pressure to the caliper. To check this...

There are three different head units available in the vehicle. The most basic one is simply an AM/FM radio, while the most advanced can play MP3s and DVDs. Some controls are universal across all of the units: In the...

The coolant level is checked by looking at the plastic reservoir (overflow) tank. You should see a min. (minimum) and max. (maximum) levels marked on the reservoir. When the vehicle is stone cold, the level of coolant in the tank...

Shaking can occur for several reasons, but most commonly is a sign of the engine misfiring. You may end up having to test the fuel, spark, and air intake systems. Start by scanning the vehicle for diagnostic troubleshooting codes (done...

Let's focus in on the fact higher RPMs have an effect on your engine's cooling system. There is only one main component in the cooling system related to engine speed and that is your water pump. The pump is powered...

The PCM supplies power to the purple/white wire which activates the starter relay. I would disconnect that wire from the PCM, mostly likely it would need to be cut somewhere it can be easily repaired or you will need to...

Your vehicle is new enough that I couldn't find much information on the air conditioning system. I'm guessing your vehicle probably has a dual scroll AC compressor in which one scroll is driven off the engine and the other is...

Hello. There are a lot of things that can cause a delayed start on this vehicle, but most of the time the issue is caused by a fuel system issue. It is caused by fuel pressure bleeding off when the...