Hi there. From the description you provided, it is unlikely, the ECM (electronic control module) is at fault. First and most important, when disconnecting the battery, always disconnect the negative terminal first and reconnect last. Starting with the positive terminal,...
The heater is a "heat exchanger" just like your car radiator. If the car is running hot and you blow air over the heater "core" in the passenger compartment you, in effect, increase the cooling capacity of the car's cooling...
Hi Travis. Thanks for contacting us tonight. When it's cold, starting a vehicle can be difficult. In most cases, a battery will have enough power to activate warning lights and accessories, but will not have enough cranking amps to activate...
Hello. You need to start by checking to see if the dome light comes on when the door is open. If it does not then the door switch may be the issue. If it does then you more than likely...
What you are describing sounds like you may have a clogged or damaged catalytic converter. The catalytic converter converts toxic exhaust gases into less harmful pollutants that are suitable to be expelled into the atmosphere. When the catalytic converter is...
Hello. From what you describe, it appears that you are being provided with conflicting information. Oil cooler lines will usually leak oil, as oil is what flows through those lines. If the engine is leaking coolant, then it is either...
Code P0122 may also indicate that you may have loose or poor connectivity to the throttle position sensor itself or potentially not enough voltage being supplied from the ECM. I would recommend having an expert from YourMechanic come to your...
Hello: There are several reasons why the coolant temperature would increase while you're stuck in traffic, in fact, it's rather normal for this to occur. Typically the thermostat on the radiator is set to release and open the coolant to...
Yes, no start in the scenario you are describing is possible especially if Code U1000 has set, along with other codes such as P0717, but there are multiple code scenarios or combinations. One quick strategy is to pull and visually...
I can understand the disappointment with how your transmission is shifting, especially since a slipping transmission can make it very difficult to drive and potentially become a safety hazard. The maintenance schedule for your Cruze recommends having the transmission fluid...
When it comes to this type of exhaust system, there is no workaround that will make it legal. If these exhaust components do not have the air quality resource tag on them, then they cannot legally be used on the...
Hello there, the traction control system is an important safety feature of your 2007 Pontiac G5. When the traction control light is on this means there is a fault that prevents normal operation of your traction control system. The problem...
The power steering pump is belt-driven off the crankshaft. Check the belt condition. If the belt is loose or on poor condition (dry/cracked/stretched), replacing it may correct the issue. Also, if the belt is loose, the belt tensioner can be...
Hello. I believe this is the security system in the "armed" or error position. Have you tried a different key fob to see if the behavior is the same? It's possible that you have a weak battery in your key...
Hi - the failure event you just experienced when returning home was almost certainly the serpentine belt failing. This would eliminate power steering assist, the alternator (which would turn on your "Battery" light and others), etc. Check for problem codes...
The lug nut bolt pattern on your vehicle is 4 x 114.3. In practical terms, that means that an imaginary circle drawn through the four "bolt holes" will have a diameter of 114.3 millimeters. Of course, a bolt pattern designated...
The water pump leak raises the possibility of the pump failing. If the pump does not turn properly that could cause noise and, if bad enough, might cause the alternator to turn slower (the water pump and alternator use the...
You do not have a timing belt but a timing chain. If the engine overheated or ran low on oil then this may have seized the motor. You will need to have the engine turned by crankshaft to see if...
Hi there. Thanks for contacting us tonight about your Jeep Grand Cherokee's starting problems. In most cases, sticking with the OEM replacement parts will produce the best results. This is especially true in regards to fuel pumps and fuel injectors....
The first thing that came to my mind was the Mass Airflow sensor, or MAF. This sensor is located in between the air filter box and the intake manifold. It is the primary sensor input for the amount of fuel...
The "VSC Trac light on" problem is related to a software problem with the yaw rate sensors calibration. This is documented in Toyota Technical Service Bulletin TSB #BR005-03, which your Toyota service center can apply to re-calibrate this sensor. [Note:...
Check the transmission fluid level and condition. The oil cooler can fail, causing loss of enough fluid to cause noise from the transmission. There is a manufacturer Technical Service Bulletin relative to parts failure in the transmission accompanied by a...
Hi there. Unfortunately, a plug & play code reader cannot determine the fault that has set the check engine light. The codes that the parts person pulled are most likely what are called evaporative emissions codes ( these codes pertain...
