Hello. This happens a lot if you live in climates with a lot of moist weather. In order to remove it, the bolt must be drilled out and extracted using an extraction bit. Once it is removed, the bolt can...
Your car includes some pretty advanced electronics, such as the Tire Pressure Monitoring system (TPMS). The TPMS is supposed to monitor the amount of air in each tire. However, if something goes wrong with the system, it will not be...
Hello. The Bank 2 Sensor 2 oxygen sensor should be the lower sensor on the passenger side. Lower meaning after the catalytic converter. A good way to remember, is that bank 1 will always be the same side as the...
Hi there. If your engine is consuming too much oil, then I would consider checking the (PCV) Positive Crankcase Vent Valve and see if its plugged up. A PCV valve can plug up causing the engine crankcase to over pressurize...
Hi there. The best thing to do is remove the radiator cap to the radiator and try to untwist the lower radiator hose if you can. If you cannot untwist the hose and the coolant is full or if there...
Hello. It really depends on the overall condition of the vehicle as to whether or not it will make that drive. Replacing the spark plugs is a good place to start maintenance, but I would definitely check all of the...
Your car has two outside mirrors (side view mirrors). They need to be adjusted properly to ensure that you can see behind and to each side of your car. Your mirrors are electronically controlled from inside the car – you...
Hello. If there is no ground getting to the starter relay then the computer is not energizing it. Typically when this occurs it is due to the computer not receiving a signal from the ignition switch or from the transmission...
The Release Parking Brake message can appear on your driver information center (DIC). When the DIC displays this alert, then your parking brake is currently engaged. If you receive this alert, release the parking brake before driving your vehicle.
Hi There, It sounds like you may have a faulty MAP sensor as the car responds to putting it in gear or otherwise putting the motor under load. The Manifold Absolute Pressure (MAP) sensor senses engine load and generates a...
Hi there. If the noise is a grinding noise and occurs on the driver side only, then yes the wheel bearing is damaged and probably dry from oil or grease. The wheel bearings are part of the wheel hub assembly....
Sport mode allows you to control the gears of your automatic transmission. To enter Sport mode, put the shifter in D, and then push it to the right. Then, push the shifter forwards, towards the +, to upshift, or push...
Hi. I'm not well versed in golf carts, but I did find a diagram online that shows the test you're talking about. With the cart turned off, there should be no continuity between any of the switch posts. When you're...
Hello there. Many different faults will cause your check engine light to flash and VSA light to be on with your 2007 Honda CRV. When the check engine light is flashing this is indicating that a fault has the potential...
The fans are controlled by a relay as well as a temperature switch and possibly timer(s). The relay may be stuck in the closed position and that would be the first and easiest component to test. If a relay tests...
The camshaft position sensor is near the thermostat and radiator hose. You will see a small black plug with wires going into it. If you need additional help with replacing this, please contact our service department to schedule a repair....
From the description you have provided it sounds like it could be, the electric power steering motor has failed. It could also be, an electrical power or ground failure to the power steering motor. Before you have the electric steering...
You’ll find three 12-volt power outlets in your car. These are designed to be used with portable electronic devices (charging your cell phone, for instance). They are NOT compatible with cigarette lighters. Using them is simple. Here’s what you need...
There are a lot of possibilities, depending on whether it won't accelerate because the engine doesn't have the power, or if it doesn't accelerate because there is a problem in the drivetrain, or if it simply isn't trying to accelerate....
Hello there, many potential faults will cause your 2013 Toyota Venza to not start after sitting. You have done well in having the battery tested already as this rules it out. The most common issues are aftermarket accessories such as...
When the system reset is used, then your cars adjustable settings will be returned to the factory settings. To perform this command, follow these steps: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed, then press...
Hi there. The alternators should working just fine. I recommend that putting the brand of alternator that is on the truck in the 160 amp size. There are different models of alternators for the Dodge Ram 1500 trucks. Some have...
You may have a problem with the interior lighting module or light switch is in wrong position. You will need to have the system scanned using a scanner that can see the interior light module and all the different door...
Hello. Thanks for writing in. vehicles that only crank can be frustrating. Although the battery may seem fine, it is always a good idea if it is over 2 years old, to have it tested. This can be done quickly...
Disconnecting the battery will not clear any codes in memory of the computer for stored OBD2 codes. The only way to clear the codes is to use a scanner and use the code clear function.
