Popular questions

Fuel pumps rely on liquid gasoline for cooling. Consequently, it is recommended to keep the fuel tank at least 1/4 full to prevent the fuel pump from overheating. If the pump is run to the point of being dry, the...

Hi. I would first recommend checking the refrigerant levels. Improper refrigerant levels is the number one cause for malfunctioning air conditioners. I suggest having the pressures checked at the high side and low side of the system. Seeing what the...

Hello. It sounds like the steering gear box and/or the power steering pump is going bad. The steering gear box is what is allowing the wheels to turn left and right when using the steering wheel. There are gears and...

Hello. If your speed sensor is failing to calibrate properly then it may be possible that there is some sort of electrical fault present, or issues with the calibration procedure. Any wiring issues with the sensor may result in the...

Your concern sounds like an exhaust leak. A leak in the exhaust system can easily cause drivability issues because the oxygen sensors constantly monitor the exhaust gases and adjust fuel trims accordingly. If a leak is present it will throw...

The brown substance coming from the radiator may suggest a more serious problem, such as a blown had gasket. When this happens, the cylinder head gasket between the engine block and the cylinder head fails due to excessive heat. This...

Hello. Unfortunately, if the tires are hitting the coils, new struts, and coils will not fix this. The clearance of the tire from the coils comes from the offset of the wheels. Larger aftermarket wheels will allow this to occur....

There are a number of things that can cause poor fuel mileage. A faulty camshaft position sensor is one of them. The camshaft position sensor is a magnetic sensor that monitors camshaft speed to regulate ignition timing and fuel injection...

Hello and thanks for contacting YourMechanic. Intake gaskets will seal, however, it is recommended to add some RTV (room temperature vulcanization) silicone to the gasket to seal it on the heads. I recommend using the blue water resistant RTV sealant...

I can't help but think that there is a little more back-story here. But I presume you bypassed the heater core because you had a leak inside the car. That's something you can do if you don't need heat of...

Used parts are sometimes acceptable; you just have to be careful and appreciate the risks. For it to be worthwhile be sure the discount is substantial. As a rough approximation, a used part would have to be no more than...

It sounds like you may have more than one issue with your car. The vibrating sounds like a wheel bearing and the clanking noise sounds like you might have a ball joint or a tie rod end that is worn...

Spark wires and boots do age, get damaged and otherwise fail. An accompanying symptom can be the arcing your describe, or voltage leakages, which simply means that the energy that was supposed to go toward firing the plug gets diverted....

Hi - most likely the overdrive sprag (a one-way clutch) in the transmission is slipping, and must be replaced. It must work properly for any forward gear to work. I would recommend a transmission inspection by a mobile, professional mechanic,...

This may be result of a failing or dirty mass airflow sensor. This is a unit that is responsible for regulating the air flow into the engine as it is mixed with fuel prior to being injected into the motor....

Hello. Engine misfires can be caused by many things. If the issue occurs under heavy load it may be possible that the vehicle requires a tune up. If the spark plugs are the originals, it may be possible that they...

If the vehicle is not driving correct after paying for the services then I would recommend taking it back to them as soon as possible as they should take you in and ensure they fix any problems. Especially for a...

Hi there. To program your locks on your vehicle to the shifter, perform the following steps: Steps To Program the Door Locks Set the parking brake Be sure that all the doors are closed Place the ignition switch in...

Hello. I hate to say that this is a common problem, and there really is not alternative way of fixing it. When the top mount wears out, this will occur causing the steering to bind. The only way to fix...

Right off the top of my head, I'd say you have a Constant Velocity (CV) joint going bad. The CV joint is the part that allows power to be transmitted through the front axle shafts even when they are steering....

Hi Alex....yes, that sensor could be a possibility but there are other components in the circuit as well such as relays (that can stick on) and, although not as likely, there are possible wiring faults that can cause continuous power...

Hello. This is a sign of a potentially blown cylinder head gasket. Often times, as a result of the car's engine overheating, the cylinder head gasket is compromised which causes oil to leak into the coolant passages and water to...