Popular questions

Question
why does the air not blow out the vents?when I hit a bump it kicks on but doesn't come back on if I turn tne car ofg.
It sounds like your mode door is not moving to the correct position to allow air flow through the panel vents. I would recommend having your mode door actuator tested to determine if it is functioning properly. The most likely...
Question
Gear oil leak.
Hello. Pinion bearing seals can leak due to normal wear or as a result of excessive pinion bearing play. A growling sound can indicate a worn pinion bearing as well. If the noise changes during acceleration, the cause is most...
Question
Fuel pump fuse blowing
One of the most common causes for fuses to blow consistently as a shorted wire. There is either a short to positive which means that one wire that has power is shorting with another wire that has power. You could...
Question
Engine "Hiccup"
Claimed by Kevin Gainer
Question
Car stopped randomly and didn't drive afterwards
Hello, thanks for writing in. The computer will go into a failure mode and may not allow the electronic throttle to open if it detects a major computer or sensor fault. There can be many possible failures that will cause...
Question
Alternator not charging
The alternator charging rate is controlled by the engine control module under the air cleaner housing. You should disconnect the battery and check the connections at the engine control module and look at pin 54 on connector one (C1). It...
Question
Carburetor leaking gasoline
Hello! It sounds like the needle valve and float in the bottom of the carburetor may be stuck which is causing the carburetor to flood with gasoline. Usually a few knocks by the fuel inlet with a rubber hammer will...
Question
Fuel pump module failure, 2014 Chevy Suburban
Hi there: Let me answer your questions in order: 1) A fuel pump module is an electrical component, so in theory it should last the life of the vehicle. However, it's common for this part to war out sooner than...
Question
Clicking and vibrating while driving and turning.
A vibrating sound could indicate a bad wheel bearing and a clicking noise while turning can indicate a bad cv joint. The wheel bearing is what the wheel rotates on and the CV joint is what connects the transmission to...
Question
What should I do if I have to leave my car for a long period of time?
If your vehicle is going to go more than two weeks without being driven, then you should run the air conditioner before leaving it. Turn your car on, leave it idling, and turn the air conditioner on its highest setting...
Question
What does the electronic power steering Warning Light mean?
The electronic power steering Warning Light is located on the instrument panel, and is accompanied by a buzzing sound. When this light illuminates, there is a problem with the electronic power steering system. This issue can reduce your ability to...
Question
How Do High-Performance Ignition Systems Differ from Standard Ones?
There are many variations of ignition systems in today's automotive market and a lot of them put out over 20,000 volts. These are the most standard ignition systems used in most engines. There are many differences in the amount of...
Question
Engine stalls and now won’t start up
Unfortunately an engine can really fail at any time for any number of reasons regardless of what year or how many miles it has on it, but it for sure isn’t normal. Toyota has a number of things that can...
Question
Service Engine Light staying on.
This code is for the oxygen sensor (O2) heater control circuit. O2 sensors in modern vehicles use a heating element to bring the sensor up to operating temperature faster. This allows the powertrain control module (PCM) to use the sensor...
Question
Car misfiring on cyclinder three, also real slow. accellerating when I come to a stop could al of this be linked together?
Hi Sharon. Thanks for contacting us today. Typically an engine misfire like you've described will also cause lack of acceleration and reduced fuel economy as well. Isolating the source of the engine misfire can be tricky, as it could be...
Question
Compressor problem
AC is a complicated system. Many things are involved in turning the compressor on. Your problem could stem from low refrigerant, an electrical issue, or a mechanical problem with the clutch or compressor. I recommend having a certified technician, such...
Question
How do I erase the personal entry codes?
All the personal entry codes can be erased quickly, by following these steps: 1. Enter the factory set entry code, which is located on the owner’s wallet card. 2. Within five seconds, press and release the 1-2 button. 3. Within...
Question
I have a ford Explorer 2002 it does not go when I put it drive now it will not go at all.
Unless there is an engine management fault (total loss of power), your issue has to do with the transmission. Check to be sure there is adequate transmission fluid as a low level can cause malfunctions. The possible causes of failure...
Question
How do you use the audio controls on the steering wheel?
If your car is equipped with audio system controls on the steering wheel (not a standard feature on all Civics), they provide you with a convenient way to work with the audio system without having to take your eyes off...
Question
Do I need to replace timing belt again of replacing water pump?
The water pump and timing belt should be replaced as a set if the coolant leaked on the belt. The coolant leaking on it will damage the belt.
Question
Horn sounds by itself
This is generally caused by a short in the steering wheel cable reel assembly, but could also be a bad horn switch, or horn relay. If the cable reel is faulty, the steering wheel will have to be removed, and...
Question
The car idles rough when in drive with the brake applied.
Hi there. It is quite possible that during the head gasket replacement, a fuel injector or ignition system component may have been improperly installed. It is also highly probable that the mechanic installed the old spark plugs instead of new...
Question
How do I use shuffle mode?
Activating shuffle mode couldn’t be easier. Simply press the SET/RND button while you’re listening to a CD, and the CD player will automatically enter shuffle mode.