Popular questions

Hi. This usually means there is a problem with the wiper transmission being worn-out or the place were the wiper arm attaches is worn-out, too. The wiper motor turns the wiper transmission, which allows the wiper blades to wipe the...

Hi there. Sounds like there are a few things going on. First the code P1313 means that the timing chain has jumped a tooth making the camshaft and crankshaft out of sync. The chain tensioner may need replaced if it...

Well, you haven't given me much to go on, but I'm Going to guess that you are seeing a Check Engine Light or some other warning light on your dashboard. When these lights come on it means the cars computers...

Hello. It sounds like the battery and/or alternator is malfunctioning and causing your vehicle to have electrical issues. If the battery is weak or the alternator is overcharging or undercharging the system, it will cause a lack of power, the...

Many different things can cause the vehicle to have a no start condition. The most common are the battery, battery cables, ignition switch, starter, or fuel pump. With the headlights not working there is a good chance that the fault...

There are many advantages to using aftermarket steering and suspension parts over factory-made suspension parts on most makes and models. A lot of it has to do with being price competitive and having better than OEM (original equipment manufacturer) warranties....

The stutter, or vibration, could be due to an engine management (tuning) issue or is possibly caused by worn motor mounts that are allowing engine vibration to transfer to the body when the engine is under load. To evaluate the...

Check the fluid level as very low fluid, or a clogged fluid filter, will result in no movement. If the fluid level is adequate, and there is no movement in any gear, the most common causes for that are: broken...

The price will vary for location for parts and hourly labor rate but this price of $700 should include replacement of all 4 sensors. If you are not quoted to replace all 4 sensors then I would suggest getting second...

Hello there. Clutch replacement in your 2006 Dodge Dakota is a large job. To replace the clutch, many components such as the transmission and driveshaft must be removed. If you are unsure at all about doing this job, it should...

The navigation system and the radio do affect each other and use each other to work. When the navigation comes on it turns the radio on as well to provide volume for the voice directions. This is normal operation and...

This can be caused by a number of things such as low coolant levels, a clogged radiator, or a failing coolant fan switch. As you may know, the coolant fan switch helps to maintain the proper coolant temperature by turning...

This could be a symptom of a bad clutch. Another way to test the clutch is to drive down the road, get into 3rd gear and with your foot on the gas pedal push the clutch in and let the...

Tire defects, uneven tire inflation (from side-to-side), bent rims, misalignment (particularly too much cross-camber from side-to-side), thrust angle misalignment, damaged suspension components, and sticking brakes can cause pulling. To have the precise cause pinpointed, and corrected, the recommended service to...

This is caused by the wiper motor. Replace the wiper motor and it will fix it. First check with dealer for any possible recalls that will fix this for free and if not replace motor.

The fuel tank sender resistance may be off causing either a short or open causing the gauge to either be full or empty. The trunk rear fuel pump access cover should be removed and the connection removed and the fuel...

This is often times related to what is called an idle air control valve which controls the air/fuel mixture at idle speed. When this is not working properly, this can cause the car to run either too rich (too much...

If you provide the parts for a repair the parts warranty you got when you purchased the part is still good. You will not be covered for labor warranty for parts replacement when you provide the parts.

Depending on the code received, you could either have separate problem or the O2 sensor code returned due to a misdiagnosis. The codes for O2 sensors can be from the engine running lean, rich, misfiring, or several other reasons. However,...

This is a sign of a failing or dirty mass air flow sensor. The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed with fuel prior to being injected into...

If you removed the catalytic converter, then that may be the cause of your noise, since it works like a muffler to slow the exhaust down, and lower noise levels. The exhaust leak would need to be located to see...

If the car does move (in reverse) then the wheel is not locked. There may be an issue with the transmission and/or the shift linkage. To resolve this, please request a transmission shift diagnostic. If you request that service, the...

Hi there. Typically an engine tapping noise is caused by either cylinder head lifters that are loose or worn out, rockers and valves not properly adjusted, a timing belt or timing chain that is loose or crankshaft / cam out...

Hi there. Tapping on the fuse box to get a vehicle to start is an indication of a possible electrical issue, possibly a damaged fuse box or main relay. Land Rovers are notorious for having these issues after about 15...