Q: Where is the yaw rate sensor located?

asked by on

Where is the yaw rate sensor located and how hard is it to replace?

My car has 180000 miles.

Hello, thanks for writing in about your Toyota Sequoia. The yaw sensor is located below the center console. It’s mounted to the floor at the rear of the console. The console needs to be removed in order to replace it.

If you need some assistance with this, consider YourMechanic, as one of our mobile technicians can come to your home or office to replace your yaw rate sensor for you.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Where is the yaw rate sensor located?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Fuel pump 2001 Toyota Sequoia

Hello - check the fuel pump fuse(s) first, then make sure the [fuel pump relay](https://www.yourmechanic.com/question/is-the-problem-my-fuel-pump-relay-or-connector-by-scott-s is passing current to the fuel pump. The relay may have burned contacts and is not passing enough current to run the pump. You may...

Q: Engine run for a few seconds then dies

Usually a vehicle that won't rev in the manner you are describing is due to a plugged exhaust system. The most common culprit here is a catalytic converter that has come apart on the inside. If this is the case,...

Q: dash and console lights out - 2005 Chevy Cobalt

Try to adjust the dashboard light's rheostat to see if it is turned all the way dim in such a way that you cannot see the lights. If the rheostat is turned up and it the lights are still not...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...